After using a solgel solution (deposition of thin films by dipcoating for example) Naoh solution was add to get nanopowder, what is the possible reaction in this case?
Dear Noua Abdelouahab, From the question it is not clear which substance was applied by the sol-gel method or what was the nanopowder?
Dear Andrei Pligovka, we add NaOH solution to metalorganic solution and we get nanopowder, so what is the possible reaction?
how can a semiconductor show better photocatalytic activity under solar irradiation rather than uv light if we consider that semiconductor has large band gap + no impurities ?
06 July 2018 1,169 4 View
Hi, I am running a size exclusion chromatography experiment with a buffer containing Potassium Acetate as a salt. I analyse these fractions through SDS-PAGE. After boiling my SEC fractions in...
01 March 2021 2,622 3 View
Favourable conditions of base pressure, rate of deposition. Also, by which characterisation technique to be used to verify the thickness of the deposited film.
28 February 2021 3,640 3 View
24 February 2021 2,362 5 View
As it is highly probable that pellets will have a higher degree of air gaps and voids than thin films, is it possible to pole the samples with corona poling nevertheless? Or is there the...
24 February 2021 1,349 1 View
I am trying to characterize an electrochromic system. The system uses ITO electrodes on glass, WO3 as the electrochromic film, and NiO as the ion storage layer. When I deposit NiO and WO3 and...
23 February 2021 9,592 2 View
I want to deposit multilayer coating of germanium and silicon monoxide on silicon wafer using ebeam evaporation?
21 February 2021 2,141 3 View
I want to measure the thickness of aluminum oxide and titanium oxide layers deposited on textured glass substates. The layer thicknesses are typically below 100nm.
21 February 2021 5,465 4 View
I have done Uv-vis characterisation of my thin film and have received absorbance and transmittance data. Now I want to calculate the absorption coefficient but I dont know the thickness of my...
21 February 2021 7,148 8 View
Is there any way to construct different initial filler shapes like triangle, square, rectangle, pillar, and tube in any simulation software.
20 February 2021 1,750 1 View
As fractal dimension of a thin film surface implies the irregularity in the surface. Is it possible that the energy states of the electrons are also affected by the fractal dimension?
19 February 2021 5,509 3 View