Pinch point temperature of Organic rankine cycle ?

27 April 2020 0 4K Report

Is it important to calculate the pinch point difference in heax exchangers for organic rankine cycles? Some authors do not involve pinch point temperature in theirs works.

Tnx in advance.

Badges
Science topic

Similar topics
Papers

More Cenker Aktemur's questions See All

How can I calculate horizontal and vertical wheel load according to Figure?

How can I calculate horizontal and vertical wheel load according to Figure ? There is no specific reference book. I need to calculate horizontal and vertical wheel load (4 wheel and 8 wheel)

15 November 2023 1,080 0 View

Why exergy cost of overall system is only 14.582 $/GJ?

Why exergy cost of overall system is only 14.582 $/GJ? Isn't the solution pump a fuel too? Why didn't you include it? Shouldn't it normally be 24,582 $/GJ?

24 November 2022 5,652 0 View

Why exergy destruction rate of solution expansion valve in absorption refrigeration system is negative?

I designed LiBr/H2O single effect absorption refrigeration system using Aspen Plus. Energy analysis is OK. However, exergy destruction rate of solution expansion valve in absorption refrigeration...

23 August 2021 7,359 4 View

Why temperature increases with adding nanoparticle to base fluid?

THEORETICAL QUIESTION Adding nanoparticles to the base fluid, for example, causes a significant increase in the temperature of the evaporator. What is the reason of this? I want to operate...

11 July 2021 5,662 6 View

Desired cooling capacity should be given as input parameter in ejector expansion vapor compression refrigeration systems?

desired cooling capacity should be given as input parameter in ejector expansion vapor compression refrigeration systems? if it is given, COP value is higher than non-given cooling capacity? i'm...

23 June 2021 6,077 0 View

Is it possible to calculate entalphy of LiBr/H2O or another solution if we know correlation of specific heat without using any software?

17 January 2021 5,917 3 View

How can I define the mixture in Aspen Plus: "Potassium formate-Water-AL2O3" ?

How can I define the following mixture in Aspen Plus: "Potassium formate-Water-AL2O3" If you know, could you please explain step by step via some screenshots from Aspen Plus ?

22 December 2020 5,346 3 View

Potassium formate/water or potassium formate+LiBr/Water are not available in the commercial sector for absorption refrigeration systems?

Although there are already studies in the literature but not much , the use of potassium formate/water or potassium formate+LiBr/Water are not available in the commercial sector for absorption...

16 November 2020 3,146 2 View

Fuel and product exergy rates ?

How to write the fuel and product exergy balances in the cascade heat exchanger in the cascade refrigeration system?

22 September 2020 2,152 4 View

Add heterogeneous catalyst substances to LiBr-Water for absorption refrigeration system ?

Is it possible to add heterogeneous catalyst substances to LiBr-Water for absorption refrigeration system ? If yes, how ?

03 May 2020 7,130 0 View

• What the possible Persistent Organic Pollutants and Heavy metals present in fluorspar, sediments, and water bodies around its mining area?

Approximate concentrations are require in compared with the WHO permissible limts

11 August 2024 2,723 1 View

Basis set and input instruction to calculate HOMO and LUMO using Orca for Imidazolium based organic salts?

Hey there, As a synthetic chemist delving into theoretical calculations for my imidazolium-based organic molecules, I would greatly appreciate any guidance on the appropriate input instructions...

09 August 2024 5,444 7 View

Do interactions between biosphere, carbon cycle, & water cycle impact global warming & interaction between atmosphere & hydrosphere?

How do interactions between the biosphere, the carbon cycle, and the water cycle impact global warming and interaction between the atmosphere and the hydrosphere?

09 August 2024 3,291 2 View

Separation of organic acids-HPLC?

Hello What should be done to separate and identify organic acids in HPC when their RetTime is the same?Like oxalic acid with Propanoic Acid.or acids that have a very close RetTime.

07 August 2024 8,782 3 View

How to convert g/kg Humic acid dose to kg/ha?

I used humic acid at 0.044 g/kg soil in my pot experiment. But finally, I have to recommend kg/ha. Each pot's soil weight was 11 kg. What is the solution?

02 August 2024 7,186 6 View

How do living organisms play a role in the water cycle and why is nonpoint source pollution potentially more harmful than point source pollution?

01 August 2024 7,061 2 View

Does anyone have issues using Prepman Ultra reagent for MicroSeq ID bacterial, fungal and yeast sample preparation?

I have been attempting to extract DNA from Bacterial, Fungal and Yeast banked samples (>1e7 cells) using Prepman Ultra reagent and I seem to be struggling to obtain a sequence. Although the...

01 August 2024 2,079 0 View

How to improve peaks separation in HPLC?

Hi everyone, I'd like to better separate two close peaks coming from a bioconversion sample, I'm currently using a C18 KromaPhase 4,6mm Ø.I. SCHARLAU, particle size (µm): 10, pore size (Å): 100,...

30 July 2024 435 3 View

What role do microorganisms play in the cycling of matter and role of microbes in the biogeochemical cycle?

25 July 2024 3,096 2 View

How to separate the stereoisomers compond in reaction mixture?

how to separate the organic reaction stereo isomers compounds are separate from the reaction mixture any simple methods are available

23 July 2024 8,025 4 View