Hi everybody
I have set up a model in comsol 5.2 which consists of a capillary. On the outlet of the capillary, I want to impose a zero gradient for all variables except pressure? how can I do this?
Thanks in advance
Hamid
Why have you not use free surface or tension surface with zero magnitude?
Hi
I think the model has nothing to do with a free surface flow or even surface tension. it is a single phase laminar flow through a channel.
PhD University Selection
31 December 2015 6,933 3 View
I’m trying to reproduce the acousto-optic coupling simulation in the paper Frequency–angular resolving LiDAR using chip-scale acousto-optic beam steering. LNOI(lithium niobate on insulator) is...
13 August 2024 9,795 0 View
What should be the equation for halfway bounce back boundary condition for flow field with forcing term?
08 August 2024 7,938 1 View
I am trying to simulate vehicular loading on an orthotopic steel deck bridge section in ABAQUS software. The red arrow mark in the attached figure indicates the direction in which the vehicle will...
08 August 2024 719 0 View
I have been getting a low plasma and no coating while doing rf sputtering of copper doped ZnS using a power of 140 watts and at pressure of 6.5x10-3 Mb.
07 August 2024 4,526 4 View
Hello, I suspect that a molecule I am using is causing bacteria to experience osmotic shock. What chemical properties should I look for to compare this capability with those of other substances?...
06 August 2024 977 1 View
My photocatalyst from solid waste red med. Dye is methylene blue My all parameter study is showing zero order. How to prove it further that the reaction in zero order?
29 July 2024 7,404 1 View
I know the difference between instrumental LOD and method LOD but my query is - in case of any sample whose concentration is zero or not detected by the instrumental LOD, is it possible to get...
24 July 2024 6,592 5 View
Hi there, I'm new to modelling with comsol. I would like to ask if it is possible for comsol to output linearly polarized (LP) modes? I tried modelling a simple single mode fiber with an enlarged...
23 July 2024 4,019 3 View
Currently I need to calculate detection probabilities (PD) from radar cross section (RCS) data. Beta distribution parameters for this RCS data are calculated and will be used in Swerling0...
22 July 2024 868 0 View
In cases where the rotational of the magnetic field H is zero, we can define this field as the gradient of a scalar function defined as the magnetic scalar potential (similar to the electric...
21 July 2024 9,633 4 View