New England Marine Bivalve and Gastropod Identification Guides?

More Matthew Pruden's questions See All

Anyone know of a good progesterone antibody?

I am looking for a good progesterone antibody to quantify levels of progesterone in zebrafish. Applications would be ELISA, and immunohistochemistry.

28 February 2021 5,929 2 View

Is there a suitable way to confine cell attachment area inside a multi-well plate?

Are there any types of cylindrical cell culture inserts that are designed to confine cell seeding area? Say, if I'm using a 12 well plate (3.5 cm^2/well), but only want to seed cells in the middle...

22 February 2021 7,127 4 View

Why am I getting such large heats of dilution in my Isothermal Titration Calorimetry Experiment?

I am trying to measure binding of calcium to an expressed protein we are studying and am getting very large heats of dilution for the calcium solution in my control tests. We prepared a 1 M CaCl2...

07 February 2021 7,532 1 View

I am looking to develop a basic oral microbiome assay. Can anyone advise on culture vessel, conditions and organisms that require minimal maintenance?

I am looking to investigate oral care products with an easy-to-prepare culture of orally derrived microorganisms.

21 January 2021 3,448 1 View

Cause of blisters in ALD layer at the edge of electrode?

I've encountered a defect during processing that I can't figure out, so I'm hoping I might find some ideas here. My mask design is a microelectrode array, with 60 microelectrodes with diameter...

19 January 2021 665 1 View

Difficult to silence gene?

I have been trying to silence a gene of interest but I could not get silencing efficiencies beyond 50% My method of detection is via RT-qPCR and samples were extracted 48hrs post transfection. Are...

09 January 2021 3,404 4 View

What form of data analysis should I use for my pilot study?

I am currently conducting my final year dissertation which is looking at the efficacy of common police lineup practices. However, before I launch my study, I have put out a pilot study which is...

08 January 2021 4,376 4 View

Is it normal to use Tris buffer when testing for bacteriostatic properties of isolated compounds?

Hello, to start off I attempting to test the bacteriostatic properties of certain compounds. I bought a kit that contains some of the equipment to perform this analysis, however, in the included...

02 January 2021 2,338 2 View

Cleaning SGE Micro Channel Device?

Hello all, I have a 3-port SGE microchannel splitter in my Thermo Trace 1310 GC connected to an Isolink 2 combustion interface. My microchannel device is clogged and my flow is significantly...

29 December 2020 7,002 1 View

Weird J-V curve of solar cell?

Recently I am getting low performance (PCE and FF) and weird J-V curves on Pb-Sn-based perovskite solar cells. I have been trying to solve this for a couple of weeks now. I will like any...

19 December 2020 9,336 4 View

Why the results when using wall thickness and when using shell conduction are different in ansys fluent?

Actually, I am running cfd simulation for a heat exchanger which has two fluids one hot and other one is cold fluid. there is a solid domain between them, which I removed and instead I have used...

01 March 2021 9,537 2 View

How do you mesh a thin solid in Fluent?

Hello, I have used the shell function on SpaceClaim to create thin solids for the model I am studying. These are contained within an enclosure for my study. I chose this approach as it avoids the...

24 February 2021 8,856 3 View

How to consider effects of rapid warm adaptation in modeling of ecological impacts of warming?

I would highly appreciate it if my fellow ecologists (biologists) provide their opinion on the thoughts below [esp., shortly tell us which path may be more effective, if they know another way, if...

15 February 2021 3,642 6 View

Buckling analysis of a cylindrical shell in Ansys APDL?

In Ansys APDL, We are trying to validate our shell model for nonlinear buckling analysis considering the initial imperfection (as given by Ahmed et. al.) We have attached our results as attached....

13 February 2021 9,200 5 View

How can I get the moment on solid elements in Finite element modeling?

Unlike shell elements, solid elements have three degrees of freedom. So how can I get the values of moments after I run the model/analysis on ANSYS / ABAQUS ?

21 January 2021 258 3 View

What species (or genus even) of crab is this (bivalve using hermit type)?

Two weeks ago I found a peculiar crab in the intertidal zone in SW Florida. when found, the crab was not utilizing a shell. It was similar shaped to porcelain crabs found in our area, but with...

17 January 2021 1,620 4 View

What refrence values should i choose for calculating the Nusselt number and surface heat transfer cofficeint?

I executed simulation for a heat exchanger (shell and tube) . but i have a question that if i dont set the reference values and leave them as default values and as you know default temperature of...

10 January 2021 1,573 7 View

Is there any analytical model to asses impact of rigid projectile on monolithic deformable plate?

I am trying to select suitable element type (Solid or Shell) for impact analysis. I have tried with both solid and shell elements. The results are same for both element types up to certain impact...

08 January 2021 3,251 4 View

Is there any relevant technique for mesocosm studies in marine environment using Nanoparticles?

I am planning to perform mesocosm study in simulated marine environment using Phosphorus based nanoparticles, i would be using marine micro-organisms in it. kindly suggest me some effective...

07 January 2021 5,877 3 View

How does titanium dioxide (TiO2) as a coating's component enhance the coating performance in terms of anticorrosion??

Greetings, Recently, I was asked by a researcher how does TiO2 enhance the coatings polymeric structure making it able to reduce corrosion reaction by preventing the penetration of aggressive...

02 January 2021 5,257 5 View

José Francisco Carrasco

The following work is a classic:

Robert Tucker Abbott et a. 1995. Shells of the Atlantic & Gulf Coasts:& the West Indies. Houghton Mifflin: Peterson Field Guides. Fourth Edition. 350pp.

Hannco P.A.J. Bakker

Which families and what depth? Most overview works aim at the larger species (e.g. 1cm +), or towards the more shallow water species. If it is not large or shallow, you might better aim for revisions per family or other taxonomical level.

Thanasis Manousis

https://naturalhistory.museumwales.ac.uk/britishbivalves/