hello dear friends
well, i'm wprking with ANSYS Fluent to simulate a cylindrical geometry. I toke the half of the model as a computational domain for symmetry reasons. when i wanna plot the contours i'd like to have the the whole section of the cylinder where the half represent the isotherm lines and the other half shows the streamlines or liquid fraction for example (see the example bellow). Waiting for your advices and help. Thanks in advance.
I think, when you enabled, the symmetry, you need to set same contour varaiable for the symmetry region, If i understand your problem correctly.
Kun Wang thank you for your interaction
Well, actually i wanna obtain the same figure attached, this last is not mine.
cordially.
Waleed Khalid no i'm using tecplot software but i can use the ansys fluent post processing.
thank you for your interaction.
In techplot, you need to go to the Data>Create Zone>Mirror.
Then create your zone of symmetry and display as you want to display your contours.
- Badges
- Science topic
- Similar topics
- Biological Science
- Bioecology
- Systems Ecology
- Landscape Ecology
- Connectivity