Angiotensin peptide stability?

Hello all, We are currently working on angiotensin analysis, however we observed that, once the freeze-dried peptide is dissolved in an aqueous buffer, it gets unstable in only 2-3 hours. Mass...

13 November 2019 787 1 View

Can anyone suggest me how to approach to design a Frequency Hopped OFDM system on Simulink?

The proposed system deals with wideband frequency hopping. The system will be able to hop between three sub-bands, with each sub-carrier having a bandwidth of 40 MHz. The three sub-bands hopping...

08 November 2019 2,574 2 View

How can I isolate mitochondrial DNA from adherent cell lines?

I have tried using the Plasmid isolation Kit as recommended by...

22 October 2019 2,118 6 View

Can microbiology pipettes be used for cell culture?

Hello everyone, We have a multichannel pipette in the microbiology lab that has been used against various pathogenic bacteria. If we want to use it for cell culture, can it be sterilised? If yes,...

08 August 2018 9,873 14 View

Can you suggest me a high electrical conductive material which i can use at 1100 C in H atmosphere

I tried graphite before but i faced ash like wearing problem. I made some research and found Inconel 601 - 617 (Nickel alloy) and TMZ alloy (Molybdenum alloy) which are hard to reach. I will try...

02 August 2017 6,741 3 View

Stress-Strain damping-strain curves for different soil medium?

14 July 2017 6,805 3 View

Does anyone know in - vitro lipolysis test?

I am trying to test lipolysis ability from certain compounds or extracts. I only know adipocyte cell line based assay. Does anyone know chemical-enzyme(chemical) reaction to test lipolysis without...

16 August 2016 4,301 1 View

How can I integrate a routing protocol in a tiny device (e.g. Raspberry Pi)?

Hi Community, I'm facing the issue of integration/compiling a new routing protocol in a WSN simulator. The final goal is to successfully add, configure this routing protocol in hardware devices...

01 March 2021 9,332 6 View

How to improve and implement WBAN MAC and Radio modules under Castalia 3.2 ?

Hello researchers, Hello Castalia3.2 researchers I am a beginner with Castalia, I work on optimization of RFID systems used in wireless body networks. I simulated a WBAN with 10 nodes and one...

28 February 2021 400 1 View

D2D implementation in Matlab in Vienna LTE software?

Hi Hope you are well. Can you please share your code for D2D implementation in Matlab. I want to implement D2D in Matlab based Vienna simulator and struggling to deploy D2D. Thanks

24 February 2021 9,378 3 View

What software programs can directly simulate Additive Manufacturing Directed Energy Deposition (DED)?

I understand there are a lot of software programs that can simulate DED by going through specific modeling, simulation, and commands. For me, that was time consuming and results were not accurate....

24 February 2021 4,428 3 View

Is it possible to set a breakpoint at a specific DYNAMIC instruction using the GNU Debugger (GDB)?

Using GDB, it is straightforward to debug and monitor a target program by setting a break-point at a specific instruction, since the instruction addresses are known. However, we have two...

24 February 2021 1,598 2 View

How the Ground Plane implantation is performed without damaging (and w/o varying the undoped nature) the top Si (8-10 nm) in FDSOI technology ?

It is a general practice to introduce Ground Plane in FDSOI devices under the BoX. The Ground Planes are introduced by Ion Implantation through Top Si layer and Buried Oxide. I wanted to know that...

24 February 2021 5,974 4 View

Langevin Dynamics in shear flow?

Hi, We are trying to simulate particles with Langevin dynamics in a shear flow by Lees-Edwards boundary conditions in MD simulations. It seems thermal forces and shear flow do not go hand in...

23 February 2021 1,761 1 View

Should I use Pressure Based Solver or a Density-Based Solver?

Dear researchers, I want to simulate a flow (air) in a wind tunnel, and I want to integrate a fluidic actuator inside it in order to control the separation of the boundary layer. At the blower...

22 February 2021 4,882 3 View

How to simulate 5G Quality of Service characteristics?

For my research, I would like to simulate an end to end 5G network. My goal is to observe the behaviour of SDAP protocol, dynamic configuration of 5QI values etc. To summarize I would like to...

21 February 2021 7,624 3 View

Open Source IoT Simulators supported by Machine Learning?

Dear Research Gaters, Let me first add context to the question. I am looking to simulate the waste management system and resources of a city. The hardware devices I need to simulate include,...

21 February 2021 2,333 4 View