We found any bubbles in DAF btw ASIC die and LF
I have run a MD simulation of a ligand-protein complex in GROMACS using CHARMM forcefield. Reviewer has asked me to calculate Ligand-activesite distance and binding free energy of ligand with...
27 February 2021 4,703 1 View
Any technique could detect the degree of litter decomposed by microbes? Or any indexes could do this job? I want to split the contribution of microbes during decomposition, so any suggestions...
23 February 2021 1,362 5 View
I am using COMSOL Multiphysics 5.5. I am trying to simulate the tensile test of PCL scaffolds. However, regardless of the strain, I have the elastic region all the time which is not true when it...
23 February 2021 4,050 1 View
Secretory universal influenza antibody CR9114 were successfully expressed by adenovirus vector ,then we used protein A G beads purify CR9114.But the molecular weight of the purified antibody under...
22 February 2021 4,318 2 View
21 February 2021 3,417 5 View
I am looking into DNA methylation of mice as an aging marker along with other assays and recently I added brain IF to the list of assays. For this, I need to fix the brain by transcardial...
09 February 2021 9,012 3 View
How could I get the P-value from the mean, SEM, and n of different groups in the t-test without the original data? For detail, I would like to know the P-value between BMP-2: 50ng/ml group and the...
06 February 2021 6,539 4 View
I synthesized 1T/2H hybrid phase MoS2 on a graphite foil surface by hydrothermal method, and then analyzed it by Raman spectroscopy. As a result, three new peaks correspond to the 1T phase were...
04 February 2021 6,580 2 View
The recommended amount of DNA for restriction digestion is 1ug in a 50ul rx I've got around 500-600ng of DNA in a total volume of 35ul. Would I get satisfactory results with this amount of DNA for...
31 January 2021 729 6 View
I'm currently trying to purify Outer Membrane Vesicles (OMVs) following their extraction from the bacteria I'm working with. After the initial extraction the concentration of protein seems good...
27 January 2021 6,852 3 View
We use reactive sputtering process to make aluminum nitride film, and want to make c-axis aluminum nitride film on a silicon substrate, but the crystal orientation cannot be seen with...
03 March 2021 7,975 3 View
I try to check the uv-vis absorption of Indium nanoparticle. Now I am measuring in solution, can I measure it in the form of a film?
01 March 2021 930 3 View
Favourable conditions of base pressure, rate of deposition. Also, by which characterisation technique to be used to verify the thickness of the deposited film.
28 February 2021 3,640 3 View
24 February 2021 2,362 5 View
Hello everyone, I'm looking for a way to delaminate copper current collector of water-based anodes in Li-ion batteries without damaging the graphite film. I tried different materials such as HNO3...
24 February 2021 3,785 3 View
I notice that upon washing and air-drying of my RGO/SPCE surface and characterizing again via DPV, the current response towards ferricyanide probe significantly decreases. My worry is that the...
22 February 2021 5,324 3 View
Hi, everyone. I am considering the heat conviction during compacting simulation by Abaqus. I was wondering that how to define the sink temperature and film coefficient? Is there any references...
21 February 2021 6,197 1 View
The regenerated cellulose film was prepared by zinc chloride/H2O system. The zinc chloride had been washed away in the regeneration process, and the wet film which was not dried had uniform...
18 February 2021 9,538 1 View
what is the reason film thickness increased when increased doping concentrations give some reasons The measured film thickness is 156, 282, 394, 548 and 681 nm for 0, 1.5, 2.5, 3.5, and 4.5 wt....
17 February 2021 8,987 5 View
Hello All! I'm trying to model a contact between a coated substrate and a tip in Abaqus. The coating is ultra-thin compared to the geometry of the substrate. So I defined the coating using the...
16 February 2021 1,594 3 View
