I was thinking to reduce the computational weight by doing some symmetry on a spur gears on ANSYS WB, that rotates 360 degrees. Is it possible to make Symmetry Region and using the half of the width gears?
Because I've tried by selecting the faces of the gears and using Symmetry Region, but I'm having issues and I think it is because I'm quiet not sure what implications related to the constrains will have this symmetry.
Prabhakar Purushothaman
kindly go through the following videos
http://www.youtube.com/watch?v=kuZWlp7EbF8
1 votes
0 thanks
- Badges
- Science topic
- Similar topics
- Engineering
- Mechanical Engineering
More Anthony Verdesca's questions See All
Similar questions and discussions