We are studying the chemical, physical and mechanical properties of mushrooms.
Dear Prof. Altuntas
There is very limited information and literature available on the chemical and mechanical properties of mushrooms, but these manuscripts can be useful: http://www.sciencedirect.com/science/article/pii/S0953756209801925
http://www.sciencedirect.com/science/article/pii/S0308814612017748
Dear Prof. Altuntas,
The answer to this question is difficult to say one sentence. The following Thesis and Book are a good guide to answer your question.
Hope this is useful,
Regards,
please check web sites:
http://www.ir.canterbury.ac.nz/bitstream/handle/10092/3792/Thesis_fulltext.pdf?sequence=1&isAllowed=y
http://library.uniteddiversity.coop/Permaculture/Mushroom_Cultivator-A_Practical_Guide_to_Growing_Mushrooms_at_Home.pdf
Dear Prof Altuntas
My Ph.D thesis is about properties (physical, mechanical and chemical) of button mushroom.
I would be happy if I could help to you.
Thesis performing and writing is in progress and it is incompleted.
I would like to learn more about SPSS and Its application especially in regards to data analysis. Please suggest me how I can learn more about it. Thank you so much.
11 August 2024 9,101 4 View
I have reverse sequences (AB1 format), can I base on reverse DNA sequences to perform nucleotide alignment, convert nucleotides to amino acids and deposit the sequence in GenBank database?
11 August 2024 5,138 1 View
Hello, Why do i see this baseline drift when i compare my blank (black) to the sample (blue)? Any suggestions as to why this happened? Thank you!
11 August 2024 3,770 4 View
Willett, Shenoy et al. (2021) have developed a brain computer interface (BCI) that used neural signal collected from the hand area of the motor cortex (area M1) of a paralyzed patient. The...
10 August 2024 7,180 0 View
I'm currently exploring the application of Python in textile engineering, specifically in areas like data analysis, process automation, and the development of smart textiles. I'm interested in...
10 August 2024 7,429 2 View
How can I use the cif data obtained from rietveld refinement extracted via gsas2, for microstructural analysis using ETEX software?
09 August 2024 7,718 0 View
Let's say we have a standard, regular hexagonal honeycomb with a 3-arm primitive unit cell (something like the figure attached; the figure is only representative and not drawn to scale). The...
07 August 2024 1,937 1 View
A fungal strain was treated with nanoparticles. We want to do an environmental SEM analysis. So could anyone share your views on preparing the sample? Thank you.
07 August 2024 5,307 1 View
I am not able to get good literature and the physics behind how first these grains and grain boundaries arises out of no where when we make a pellet to study its dielectric properties and then how...
07 August 2024 5,177 3 View
Hi, I have a question about normalizing the MTT OD values for doing the statistical analysis. So, if we have 3 different plates and we call them 3 different replicates, so, first we would...
07 August 2024 8,106 4 View