I am interested for the UV spectra of vitamins.
Try sbds
SDBS is a nice source, check it out at
http://sdbs.riodb.aist.go.jp/sdbs/cgi-bin/direct_frame_top.cgi
Theodore / Serdar
I did not find UV-spectra in SDBS?!
Furthermore it provides an IR-spectrum of my favorite molecule, glyoxal, as a water solution; but then glyoxal is present in the trimere-form, not the pure monomere
My protein is of ~11 kDa. While eluting from the Gel filtration column, It comes with the MBP tag. I did cleavage to separate tag from the protein. So other impurities are removed but the MBP tag...
07 August 2015 978 13 View
I want to compare the thermodynamics of the two end of the dsRNA. Is there any software available? Is there any reference paper by which I can find the local thermodynamic parameters of the RNA at...
01 February 2015 5,571 3 View
How do I convert the fret Eapp data to the dwell time?
10 November 2014 4,827 2 View
I need to purify His6 tag containing protein. Normally I use lysis buffer containing EDTA and DTT for preparing cell lysate. So can I use same buffer by adding imidazole for chromatographic...
08 September 2014 6,006 8 View
Is there any other way than affinity chromatography to separate the protein? How much TEV to protein ratio can be used for TEV cleavage? Also can any one suggest the conditions to be used for the...
08 September 2014 7,922 7 View
Is there any comparative study of protein purification or separation by using reverse phase HPLC and fast protein liquid chromatography (FPLC)? What are the criteria for separation of protein by...
02 March 2014 2,263 1 View
I want to study these methods for a project. Please also give retention time and retention factor for as many drugs as available.
06 July 2013 568 3 View
Is there any way other than prediction from signal to noise to ratio? In case of s/n, the s/n for the peak near its base should be considered or the ratio should be calculated from the base line...
01 February 2013 5,957 17 View
for example, ODS, synchronus, hypersil, nucleosil, etc.
31 December 2012 641 10 View
I have collected the physical and chemical data from three batches. Is this sufficient for the development of in house standards? how do I proceed with the data available?
11 December 2012 2,436 0 View
Is There Any Feasible Method To Test The Efficiency Of Fluorescent Compounds Other Than UV Spectrometers ? Suggestions Would Be Appreciated !
02 March 2021 5,785 3 View
I am doing my thesis on the nutrient deprivation on the macroalgae Rhizoclonium sp. I will be analysing the levels over a period of roughly 5 days by HPLC-UV and GC/MS. I will be using seawater as...
28 February 2021 6,477 1 View
I am currently doing research on the adsorption of heavy metal using magnetic reduce graphene oxide. I use AAS to determine the concentration of the heavy metal. I prepare the Pb solution with...
26 February 2021 9,580 4 View
I am trying to analyze lipase using the reverse phase-HPLC C18 column. In the literature, 0.1 % TFA was and 60% ACN was used. Can I use TCA in place of TFA? If any other methods are available to...
25 February 2021 2,388 3 View
How to do acid digestion of soil sample with 3:1 aquaregia in an open vessel?
23 February 2021 3,053 7 View
I need to simulate the optical properties of a biomaterial, namely DNA, in COMSOL. Basically I need to simulate the IR absorption spectrum of a cylinder filled with a 'concentration' of DNA. I am...
21 February 2021 3,043 3 View
Hello, I'm working on removal of methylene blue. 01. in the dark test very first reading is taken 15 minutes after adding adsorbent to the dye solution and that UV absorbance reading is very...
19 February 2021 472 5 View
Hello, I am observing a nearly periodic background spectrum for a wide variety of SERS substrates. I see this response (attached below) for bare Au films, Cu films, and Au nanoparticles on...
15 February 2021 9,922 5 View
Hi! I am looking for some specific information in regards to the minimum amount of UV intensity required to begin the photo degradation process in polymers. I understand each polymer is...
15 February 2021 7,703 4 View
Currently, I am working on PLA-PEG copolymer micelle for the drug delivery system. I have seen several papers where some researcher talks to centrifuge the drug-loaded micelle to separate the...
13 February 2021 5,822 7 View