Is there any possibility to make lithium metal soluble in room temperature liquid metal alloys??? If yes then how???

10 October 2015 0 3K Report

Is Simple annealing ok for this????

Badges
Science topic

More Naveed Hussain's questions See All

Can one observe surface plasmon resonance enhanced photoluminescence in a single semiconductor system???

Respected Researchers !!! I have observed remarkably enhanced (282-fold) PL emission from Bi2Te3 nanosheets. However, its bulk counterpart being a narrow indirect bandgap semiconductor exhibits...

11 December 2017 7,165 4 View

How do I detach my ultrathin film sample from silicon substrate to perform TEM?

Hi... 1) How do I detach my ultrathin film sample from silicon wafer/ quartz(substrate) to perform TEM? I have tried ultra sonication for one hour but couldn't succeed. 2) Is there any sound...

03 April 2016 374 17 View

How do I synthesize a nanocomposite of Ni and SnO2?

I want to make a nano composite of Ni and SnO2 with different compositions. Which method should i chose for its synthesis and how can i do it???

10 November 2015 7,067 9 View

Problems about acousto-optic coupling in Comsol, how to check whether the moving mesh is correct?

I’m trying to reproduce the acousto-optic coupling simulation in the paper Frequency–angular resolving LiDAR using chip-scale acousto-optic beam steering. LNOI(lithium niobate on insulator) is...

13 August 2024 9,795 0 View

Is there anyone with experience in TEM analysis who can assist with a manuscript for an upcoming journal?

Hello dear colleagues, We have prepared a manuscript on NiTi-based alloys and are seeking a second opinion on our current TEM results. If you are a Ph.D. holder with experience in TEM and have...

07 August 2024 9,563 0 View

What is the solvent for 8YSZ nano material?

I need to do some experiment with it in liquid form.

07 August 2024 613 3 View

Hi, please what is the best tool on Aspen plus that can help me get the best inlet temperature and pressure for cryogenic distillation?

I am trying to recover liquid CO2 from a mixture of 0.6 CO2, 0.3 N2, and 0.1 O2. My aim is to recover about 99% liquid CO2 at the bottom of the column and make sure the amount of gaseous CO2...

06 August 2024 4,611 0 View

How much Yeast should we add to fermentation media?

I have prepared a liquid broth containing Yeast (S. Cerevisiae) that i need to add from it to fermentation media of lignocellulosic hydrolysate. I need to know based on what parameters do we add...

06 August 2024 662 1 View

What is saturation solubility of insulin in saliva?? I need it to know sink condition ?

05 August 2024 4,407 0 View

What is the best protocol for freezing the rat brain in preparation for protein detection by Elisa ?

What is the best way to freeze the rat brain - liquid nitrogen, Dry ice , isopentane - after isolation for later protein investigation by Elisa?

01 August 2024 1,722 1 View

How select composition for ods-high entropy alloys?

31 July 2024 2,795 1 View

How to explain the different interaction between soluble and insoluble polymer in water?

Hello everyone, I am try to understand the differences interaction between insoluble and soluble polymers in water with metal ions and how theit charge density (of metal ions) affect the interaction.

29 July 2024 6,350 3 View

What is the solubility of Iron (+3) in Bismuth Oxide?

Dear all: I am modifying Bismuth Tungstate with Hematite (Fe2O3), so I would like to know about how much Iron(+3) can form a solid solution in a Bismuth Oxide matrix. Best wishes Marco

29 July 2024 2,163 1 View