Is there any open source platforms to simulate profiles of main properties of an axisymmetric capacitively coupled rf plasma?

More Bidyut Chutia's questions See All

Application of inferential statistics?

Can we use inferential statistics like correlation and regression if we use non-probability sampling technique like convenient or judgement sampling?

27 December 2023 4,283 13 View

Can any expert help in solving the following DSC curves?

I have two DSC curves, attached below. One of them shows an endothermic peak at 90 and another one at 71⁰C. Are these two peak shapes glass transition temp (considering enthalpy relaxation...

03 November 2023 4,008 11 View

What does the unstandardized regression coefficient in simple linear regression means?

What does the unstandardized regression coefficient in simple linear regression means? Where as in multiple linear regression Unstandardized regression coefficients tell how much change in Y is...

05 October 2023 7,047 2 View

Fluorescence lifetime for excimers: How to detect the rise time?

Below is my fitted data of FL lifetime of a compound in solid state after fitting into biexponential components which shows one component to be positive amplitudes (denoted by B) and the other...

20 September 2023 9,142 4 View

Can there be charge transfer from solvent to solute in excited state?

I have a compound under investigation for its photophysical characteristics, and during investigation of its emission spectra with varying polarity I observed a red shift from low to high polar...

04 July 2023 8,092 3 View

What could be the probable reason for splitting of the ESR peak (as attached)?

I have a solid state X-band ESR spectra of an organic compound, as attached here. Unlike normal spectra, the spectra of my compounds seems to be peculiar in nature. What could be the possible...

15 February 2023 9,470 1 View

Can the g-factor of a compound be greater than 2.003 ?

An EPR spectrum of an organic compound was recorded on solid state which resonated at around 83 mT but on calculating the g-factor the value came out be nearly 8.00 which is too high than...

27 November 2022 8,281 4 View

What could be the probable reason for dual emission as discussed below?

I have an oxindole derived compound. To study its photophysics the compd was dissolved in DCM with varying concentrations but when emission was recorded it was observed that at low concentration...

15 November 2022 4,305 2 View

How to assess the advantages of processing on edge devices with cloud design by plotting bandwidth and latency reduction?

I created a system that continuously classifies the system's state by reading sensor data (time series data) connected to this device. The goal of this effort is to reduce bandwidth and latency by...

24 October 2022 3,977 3 View

How to measure mean annual and mean seasonal seasonal discharge from daily data?

I have daily discharge data in the period between 1950 and 2010. How can I calculate "mean annual" and "mean seasonal" discharge from the daily data.

11 July 2022 1,671 0 View

Why do i have a weak plasma and no coating during rf sputtering?

I have been getting a low plasma and no coating while doing rf sputtering of copper doped ZnS using a power of 140 watts and at pressure of 6.5x10-3 Mb.

07 August 2024 4,524 4 View

How much total RNA concentration to be extracted from sorted plasma cells from bone marrow of C57BL/6 mice for RT-PCR ?

i have sorted anti-NP specific plasma cells from bone marrow of C57BL/6 mice at certain times after immunization with variable counts and isolated total RNA using TRIZOL method for RT-PCR using...

05 August 2024 8,835 1 View

Can anyone explain why there is not any color bands in the middle portion of the tensile coupon?

Details of the Analysis. Static Analysis Composite Layup Continuum Shell Elements FRP Material (Elastic and Hashin Damage)

03 August 2024 8,537 4 View

When I simulate for S parameters using ADS, I have faced this issue that I have attached. Please anyone clarify me?

...

31 July 2024 1,671 3 View

Why specific capacitance is not proportional with the specific surface area?

Dear researchers, Why specific capacitance is not proportional to the specific surface area? I have material A with a surface area higher than material B, but material B is showing little bit...

26 July 2024 9,156 2 View

Why might I be observing hysteresis in my stress-strain curves when using the Mohr-Coulomb model, despite not applying dynamic loading?

While working on caisson foundation, I applied static vertical load

25 July 2024 9,357 1 View

How to select relevant metabolites from multiple annotations ?

I am using the Polyomics Integrated Metabolomics Pipeline (PiMP) for metabolite feature analysis. After annotating my data, I have encountered cases where multiple potential metabolites are...

24 July 2024 5,789 0 View

Wrong out put for gmx x2top?

Dear users, I would like to simulate a zeolite structure in gromacs. I got the .cif file from IZA expanded in one direction in Materials Studio and exported a .pdb file. However, when I want to...

24 July 2024 365 4 View

What are the strategies to Enhance IgG-Producing Plasma Cells in mice for Monoclonal Antibody Development?

I have immunized BalB/C mice with a protein using the intradermal (ID) method with Complete Freund's Adjuvant (CFA) and Incomplete Freund's Adjuvant (IFA), following a 14-day interval and three...

22 July 2024 9,158 2 View

Can a private laptop with 16GB RAM and Intel i5-1235U 1.3 GHz processor be used for WRF simulation with a 12*12 km domain?

I want to simulate WRF for a 12*12 km domain size. I want to run LSM and BSM models with a 5 minutes time interval. My laptop specification is 16GB RAM and Intel i5-1235U 1.3 GHz processor. Can I...

13 July 2024 2,036 0 View

Andrew Somorjai

There's xoopic, not sure if it can do that but it's open source. You'll need to compile xgrafix on linux with make and then compile xoopic to use it.

Bidyut Chutia

Thanks for the response. But is there any fluid theory based code?

Bidyut Chutia Openfoam does have an MHD solver, although I doubt that could simulate what you are asking, looking at the solver could be useful.