Is there any literature which deals with the physical properties of putrefaction transudates?

More Achim Reisdorf's questions See All

Was ist das für ein statistisches Design (psychologischen Studie)?

Wir haben folgendes Design: AV: Akzeptanz von Algotithmen Es gibt drei Gruppen: a) ohne Hinweistexte, b) mit sachlichen Hinweistexten c) mit emotionalen Hinweistexten Die Probanden sollen die...

02 May 2024 4,296 4 View

Is there a dual registration of one paper in RG?

dear RG-team! for several times already, I recieved information about citations of my paper as copied out below. Obviously, there is only one paper that was cited. On the other hand, RG mentiones...

25 April 2023 8,971 0 View

What is the mass of Kajtar particles in SPH?

Hello, I am trying to follow this article https://www.sciencedirect.com/science/article/abs/pii/S0010465509001544 SPH particle boundary forces for arbitrary boundaries In the article when they...

16 November 2021 1,318 2 View

Are there tools to predict the buffering capacity of a concentrated protein solution?

There are many excellent tools to predict protein properties that are only dependent on the sequence of a protein, such as protein molecular weight or protein pI (examples would be the pi_tool on...

13 September 2021 8,751 3 View

Is this the fragment of a sauropod tooth?

Dear colleagues. Fragments of this species are very rare from a terrestrial Lower Cretaceous locality from Germany. Up to now from this locality sauropods could not be proved with certainty. Other...

14 February 2021 2,631 1 View

What are the boundary conditions for the velocity in SPH for the case of a nozzle?

Hello, I am trying to model, using weakly compressible SPH, a system with a nozzle in which a jet is entering the simulations box with constant velocity, similar to the image shown. I set-up...

19 September 2019 5,027 1 View

What is the Gradient of a constant Pressure in SPH?

Analitically gradient of pressure is the same using P=c*c*rho or P=c*c*(rho-rho_0). However when studying the effect of gravity in a system with constant inflow of air, I found that the second...

11 December 2017 3,880 2 View

Is there a standard method for separating technical variability from biological variability?

We have a proteomic dataset where many proteins have been identified in samples derived from two classes of samples with three biological replicates each. Each of these samples was analysed...

25 November 2015 1,091 4 View

What is the best way to prepare and clean the selfreported unbalanced MIX dataset?

Dear all, my master thesis deals with the research question what drives the capital structure of microfinance institutions. I retrieved unbalanced panel data from Microfinance Information Exchange...

06 July 2015 5,088 1 View

Does anyone know companies which can supply me with materials for humanized mouse model?

HEMATOPOIETIC STEM CELL ENGRAFTMENT OF ADULT IMMUNODEFICIENT MICE Materials needed; NOD/Lt-scid IL2rγ null mice: males or females, 5 to 12 weeks old (official strain designation,...

29 December 2014 1,046 3 View

How to calculate CCS for Sodiated adduct ions and Multiply Charged Ions?

I'm currently working on calculating the collision cross section (CCS) for various ions, and I'm facing challenges when dealing with sodiated and multiply charged ions. Most of the resources I’ve...

08 August 2024 8,329 0 View

Hello Everyone ! I'm looking for a good journal to publish my manuscript with low publication cost?

I am Looking for a Science Journal with good impact factor and low publication cost to publish a review paper. Your suggestions would be appreciated.

06 August 2024 6,796 3 View

Any idea about 'International Research Journal of commerce , arts and science? Is it a UGC listed journal?

Any idea about 'International Research Journal of commerce , arts and science? Is it a UGC listed journal? Kindly advice

04 August 2024 7,367 3 View

Are authors sowing for scientific Journals to be reaping the benefits? We are charged for publication but we offer free peer review services, why?

As authors and academic writers, we usually prepare our manuscript using our own resources. We submit these manuscripts to scientific Journals for peer review and publication sometimes at a fee....

03 August 2024 7,304 2 View

Is it true that science is leaving the era of mathematics and entering the era of matrix mechanics?

We assume this to be true. Science leaves the era of mathematics and enters the era of matrix mechanics and the turning point is the discovery of numerical statistical theory called Cairo...

31 July 2024 3,900 2 View

Posthoc test lettering in JAMOVI?

Does anyone know of a module for the JAMOVI software that is capable of generating mean separations using the classic letters based on post hoc results (e.g., Tukey test)? If, as I believe, such...

31 July 2024 3,333 4 View

Inquiry on Maximum Nucleic Acid Volume for 2.5 mL Liposome Solution?

I am currently working on a project involving liposomes and need to determine the maximum volume of siRNA that can be added to a 2.5 mL liposome solution with a total lipid concentration of 10...

30 July 2024 6,420 1 View

May I know the exact Quartile of the journal- Advanced Engineering Materials (Wiley) for material science category?

In some data sources it has been grouped in Q1 and some shows it is Q2.

29 July 2024 4,227 2 View

How can I use DFT-D3 correction ( Siesta version 5.0.1)?

Dear Siesta Users, I installed Siesta 5.0.1 and I want to use Grimme's D3 correction. According to the 5.0.1 manual, I could use a few parameters to include the D3 correction in the...

27 July 2024 5,748 0 View

EDC carbodiimide and NHS easter 's half life among different pH?

It has been long known that EDC carbodiimide and NHS easter's half life agains hydrolysis are highly related to pH. However, very surprisingly, not yet found a paper giving a table/chart of their...

25 July 2024 8,738 0 View

Amy Rattenbury

Hi Achim

Are you looking for information on things like chemical changes during the putrefaction stage or more on a scoring system used to define 'how putrefied' something is? Or something else entirely. If it is either of those I may be able to help, my are is in forensic taphonomy and decomposition.

Thanks

Amy

Achim Reisdorf

Hi Amy,

Thank you for the offer! Information about chemical changes during the putrefaction stage are highly welcome, too. Besides that I search for data about physical properties of putrefaction transudates, including relative density as well as Reynolds number (at different temperatures, pressures and chemical compositions).

Best wishes, Achim