Is there any difference between Cathodic Arc Evaporation and Cathodic Arc Ion Plating techniques?

More Vasiliy Pelenovich's questions See All

Non degenerate function and series Fourier?

1. Определение. Существует известная теорема, представляющая интервал в виде конечной или счетной суммы попарно непересекающихся интервалов. Сумма длин этих смежных интервалов равна длине...

08 June 2024 8,620 4 View

Is it possible to use dummy atoms in generalized internal coordinates (GICs) in Gaussian?

I found out that there is a great function for making scans in Gaussian - GIC. Unfortunately, I ran into a problem - the inability to add dummy atoms to the input file. In several questions on...

15 November 2020 1,164 2 View

What is the technique for precise determination of carbon phase composition by analyzing Raman spectra?

In MRS Communications, Volume 8, Issue 3, pp. 1343-1351 (2018) one can read: 'The peak fitting of the Raman spectrumusing the Gaussian distribution function gives the percentage of sp3 carbon of...

24 September 2020 5,554 5 View

Newton's Second Law of the third order?

The function assumes a direct and reverse law. What do we know about the inverse function? Never mind. This is just the shadow of the direct function. Why don't we use the inverse function, as...

03 November 2018 4,585 49 View

What is "latency to find the platform" in Morris water maze test?

Sometimes mice find a platform, but ignore it and continue to swim or immediately jump off. I thought, can this be seen as a manifestation of learning? That in this case to consider latent time...

17 March 2018 8,827 2 View

Can I use the Morris water maze test for assessment short-term spatial memory?

Morris water maze usually used for assessment long-term spatial memory during acquisition trial (Usually it is 24 hours or more after training). Can I use the Morris water maze test for...

09 March 2018 4,838 6 View

What went wrong in my equilibrating polymer melts via Molecular Dynamics?

I am wanting to simulate polymer melts. I created the initial files using the chain.f tool built in Lammps, and running the simulation protocol from the paper attached. When equilibrated my melt...

23 September 2014 4,864 6 View

Adhesion strength of coating?

How can I determine a good adhesion strength range for coatings on polymer surfaces, such as DLC on polymer substrates? Is there a specific threshold for adhesion strength (from T-peel tests)...

10 August 2024 942 3 View

How do I conformally do PR spin coating on trench structure?

I did PR spin coating on trench structure. I used AZ P4620 PR and the thickness or PR is around 11um. The substrate is Si. And my trench structure depth is 141um(negative way). Even though I...

08 August 2024 2,298 0 View

Is changing the medium during the experiment overestimate the results?

I am experimenting with cancer and non-cancer cells in a 12-well plate for 4 days with a seeding density 1*10^4/well, however, I noticed that the control group growth rate slows down on D3. Should...

07 August 2024 2,283 2 View

Why do i have a weak plasma and no coating during rf sputtering?

I have been getting a low plasma and no coating while doing rf sputtering of copper doped ZnS using a power of 140 watts and at pressure of 6.5x10-3 Mb.

07 August 2024 4,526 4 View

How to normalize and take the significance of the MTT OD values with 3 replicates for the same cell-line?

Hi, I have a question about normalizing the MTT OD values for doing the statistical analysis. So, if we have 3 different plates and we call them 3 different replicates, so, first we would...

07 August 2024 8,106 4 View

What procedure should I follow for current controlled PPy film electrochemical deposition on ITO?

For example, I perform passivation process before electropolymerization of Py for adhesion to titanium surface. Is a similar or different procedure required for ITO? If necessary, I would be glad...

06 August 2024 3,176 0 View

Can you recommend a 96-well plate for minimal cell adherence to the wells during phagocytosis experiments?

I have been performing short phagocytosis experiments using 96-round bottom, tissue culture treated, well plates (Falcon, 353077). I culture the cells with the phagocytic cargo for 2-4hrs, wash...

04 August 2024 5,228 4 View

PBMC infection with virus?

In my study, I intend to infect PBMCs with SARS-CoV-2. After that, I will analyze NK cells by flow cytometry to see if their phenotype changes or if they show degranulation. After the infection, I...

01 August 2024 4,403 4 View

Found this object in the cell culture - do you have any suggestions what it might be?

Dear researchers, Today, we found this object in one of the wells of a 96wp culture plate. The plate contained MEC-1 cells and GelTrex. I am quite curious what this is (because it's not cells). Do...

01 August 2024 2,250 2 View

Publishing a checklist?

Does anybody know of entomological Journals without page charges that would publish an extensive checklist (Hong Kong Aculeates wasps) covering 350 species (of which more than half are new to Hong...

01 August 2024 6,134 2 View