What is the state of the drug inside solid lipid nanoparticles (SLNs)?

I am a little confuse with the mechanism of solid lipid nanoparticles (SLNs). The main point of encapsulating drugs into SLNs is because some drugs have low solubility in water. Therefore, SLNs...

01 March 2021 3,703 3 View

Is there association of SARS-CoV-2 infection rate with meteorological factors?

There are contradictory research papers about the correlation between meteorological parameters and incidence of COVID-19 in some countries worldwide. Is there correlation between the...

15 February 2021 5,806 2 View

Why does the band sizes on Agarose gel electrophoresis differ from the peaks at capillary electrophoresis?

14 February 2021 4,773 4 View

How to calculate the Boiling point for metals at high vapor pressure?

In our experiment, some metal surfaces are exposed to radiation heat under high vapor gas pressure. I would like to ask if there is any way to calculate the boiling point for metals under high...

31 January 2021 249 4 View

What test should I use after a significant factoriual ANOVA?

Dear Colleagues Several resources recommended following significant interaction ANOVA with a simple main effect analysis to break down and interpret the interaction. I am wondering if I can...

29 December 2020 8,316 4 View

In your opinion , What is the percentage of demand for accountants and the percentage of stagnation ?

in your opinion , What is the percentage of demand for accountants and the percentage of stagnation ?

24 December 2020 5,349 3 View

How can increase the follower and citations of my articles?

I am looking for increasing the citations and reading my articles around the world.

13 December 2020 7,074 3 View

How to do energy optimization of charged molecule in gaussian?

when we want to study a reaction with a charged molecule (+) or (-) located on an atom, how do we optimize its structure with gaussian 09 thanks

29 September 2020 4,873 6 View

How can I do quantitive scoring for immunohistopathology(IHC)?

Is it enough inserting IHC image or quantitive details should be done, and how can I do this and what parameters needed ?

22 September 2020 1,881 2 View

Suggestion for the MS research topic?

hello everyone i have done work on NUMERICAL MODELING OF BRICK MASONRY in BSc. Now i want to carry the same/related work in MS too. i need your precious suggestions. Anyone having idea/topic...

14 September 2020 7,693 1 View

MD MOE RMSD

How to calculate the RMSD values for a MD simulation using MOE?

07 August 2021 0 0 View

MD MOE RMSD

How to calculate the RMSD values for a MD simulation using MOE?

07 August 2021 0 0 View

fatal error

When I tried to energy minimization my system, I got fatal error as below. Fatal error: Atomtype opls_116 not found Although I've already added this line: ; include water #include "oplsaa.ff/spc.itp" to [molecultype] directive in my topology.

16 June 2021 0 0 View

fatal error

When I tried to energy minimization my system, I got fatal error as below. Fatal error: Atomtype opls_116 not found Although I've already added this line: ; include water #include "oplsaa.ff/spc.itp" to [molecultype] directive in my topology.

16 June 2021 0 0 View

fatal error

When I tried to energy minimization my system, I got fatal error as below. Fatal error: Atomtype opls_116 not found Although I've already added this line: ; include water #include "oplsaa.ff/spc.itp" to [molecultype] directive in my topology.

16 June 2021 0 0 View

fatal error

When I tried to energy minimization my system, I got fatal error as below. Fatal error: Atomtype opls_116 not found Although I've already added this line: ; include water #include "oplsaa.ff/spc.itp" to [molecultype] directive in my topology.

16 June 2021 0 0 View

What kind of fluid could I use for a pitfall trap that also does not invalidate molecular testing?

Hi, I want to start testing pitfall trap to obtain ants samples, but I need to conduct molecular analysis on those insects. So, what kind of fluid can I use? Ethanol expires too early and I need...

03 March 2021 5,978 5 View

How to repeat an operation on an atom selection for multiple times in PyMol?

Hi, I am trying to construct a multi-layer fibril structure from a single layer in PyMol by translating the layer along the fibril axis. For now, I am able to use the Translate command in PyMol...

02 March 2021 4,569 4 View

New Journal, "Integrative Psychological and Behavioral Science" -- do you not know, and have you not seen, this done before?

Question to you and THEM, the New Journal, "Integrative Psychological and Behavioral Science" -- do you not know, and have you not seen, this done before? There appears to be a core problem for...

02 March 2021 3,024 2 View

Do anyone here can help us in the field of molecular docking?

We have synthesized various metal complexes with different environment around the metals. Now to see the application of synthesized complexes we need this study also. we are also interested in...

01 March 2021 1,899 2 View