Trying to determine the ratio of biochar application on surface area of 5m x 10m (50 square meters)/clay/sand/loam soils. Any technical advice?
Present studies are being carried out with doses from 5 to 40 Tons/ha. I think 10 to 20 Tons/ha are the most usual rates.
Thanks for the response.
You are interested in developing a clear, repetitive and automatize processes for model productionalization, which would include model validation, model assessment and maintenance as well as the...
01 February 2016 7,761 0 View
I have over 5 years developing predictive models with years of experience as a researcher, statistical analyst as well as data scientist. One aspect that I have experienced within the big data...
31 December 2015 3,502 47 View
The development of a predictive model is a complex process, which encompass several challenges, assumptions, theoretical implications, and an understanding of the reality of what is being modeled....
31 December 2015 2,900 6 View
Over the past years of my education in Ghana and the United States, I have come to recognize the vast distinction in teaching-learning outcomes between a professor without the teaching...
31 December 2015 7,046 4 View
What are the main factors or indicators you take into account that may or may not influence your choice to submit manuscripts to a potential journal publishing entity?
31 December 2014 7,336 3 View
I am currently writing up a thesis of an11-months field research Lao PDR. I have talked with my supervisors about publishing results base on each of the 4 objectives in several specialize...
11 December 2014 2,374 6 View
The analysis of variance (ANOVA) shows that mean yield among treatments used in an experimental trial were highly significant. However, the result did not show which of five the treatments yield...
10 November 2014 9,076 18 View
Data generated at the field through field-based monitoring and assessment include climate data: temperature (C), relative humidity (%), wind speed (mph) and direction, dew point, precipitation...
10 November 2014 7,635 15 View
The normality test is a test, which once computed tells you an assessment of whether or not the range of your data is normally distributed, which is a prerequisite for many statistical tests...
10 November 2014 8,787 4 View
Hi, I'm looking for data (mainly related to management: growth rate, canopy size, soil and climate preferences, etc.) about tropical trees used in tropical agroforestry. Have you ever heard about...
28 February 2021 7,356 8 View
it is published by Juniper
28 February 2021 354 4 View
I'm an Undergraduate student on the search for a research topic which has to involve any ecosystem service(s) and a response to environmental change. I'm looking for raw quantitative data sets (I...
19 February 2021 5,911 2 View
The Gower peninsula around Swansea is my target area
16 February 2021 7,473 3 View
Most of the references I found were on the economic productivity in agriculture but very limited application in manufacturing sector. I would appreciate if anyone could share the references on...
15 February 2021 8,342 7 View
I am looking for a copy of the resume book of UEP2013 Asian Edition (Urban Environmental Pollution 2013 Asian Edition) held in Beijing. If somebody has it, please I would like to obtain an...
11 February 2021 2,247 2 View
I want to run 5 different models to estimate stream flow. In order to optimize the characteristics of these models I use Taguchi method. So I have to run different models according to the Taguchi...
11 February 2021 7,986 6 View
Power-to-heat (P2H) shows how we can use renewables for heating. Power-to-heat technologies have been on the market for quite some time now, with heat pumps being the most important. However, they...
10 February 2021 9,250 2 View
The hourly load curves of the selected household in each season are shown in Fig. 28. Figure 28 shows the demand for electricity in four months on an hourly basis. Can you explain this diagram to...
08 February 2021 657 16 View
Design for Sustainability (DfS) is a wicked and complex problem. It needs the designer to combine specialized knowledge from several disciplines with systemic thinking. The designer also needs to...
05 February 2021 2,998 9 View