Is there a problem with swat output file- reservoir data (output.rsv)

01 January 1970 0 5K Report

Dear all,

During the model setup, reservoir 1 and 2 have different storage volumes. 1 is 10X larger than 2 but I get same volume in the output file.

Also, the flow out from the dams (reservoir) are larger than the flow in values. See attached picture. What could I have possibly done wrong during the model setup. I think that is why the model is overestimating my flow values. Please help

Badges
Science topic

Similar topics
Correction

More Collins Acheampong's questions See All

Can CMOS and CCD images sensors be used as microphones?

I was thinking about Msps and Gsps image sensors in different environments. If a pair of identical image sensors - one exposed to air, gases, plasmas, or partial vacuum - and one in a good...

21 December 2020 9,747 2 View

Proper method for assessing model invariance following Confirmatory Factor Analysis (CFA) and preceding 2x2 between-subject analysis?

I have produced a good-fitting, reliable baseline model according to CFA. The model contains several factors each loaded by several categorical (ordinal) items. I ultimately intend to analyze the...

15 December 2020 1,668 4 View

Hello researchers, can anyone help me with this Structural Decomposition Analysis (SDA)?

I am using Economic Input-Output Life Cycle Assessment (EIO-LCA) model I need to decompose this equation W= P*F* L* Yc* Yg to generate 120 forms. where W is a vector of total water withdrawal...

20 November 2020 4,194 3 View

How do I better visualize protein interactions at edges of periodic box in VMD?

I have a 500 ns molecular dynamics trajectory with several proteins in a membrane. The entire system is enclosed in a periodic box. Unfortunately, my proteins are only interacting around the...

11 November 2020 6,912 3 View

How does one decribe an HPLC chromatogram in a results section?

I happened to use HPLC in a project and the chromatograms are out. As a biologist, I don't really have the technical understanding to fully interpretate the results. I would like to know what to...

16 October 2020 7,006 5 View

Which part of the ovarian follicle in poultry can I use for RNA and protein extraction. The outer layer or the inner fluid?

Should I use the covering of the follicle or the liquid fluid for RNA and protein extraction. Which technique is easier to use

01 September 2020 3,094 3 View

How expensive are commercially available customized molecular dynamics services?

I am interested in potentially using commercially available customized HPC molecular dynamics simulations. However, I cannot find pricing information on the websites of the vendors. Could someone...

07 June 2020 9,137 3 View

What is the role of journals' reviewers? Should they be absolute judges?

- Ask questions where they are not sure/convinced about a statement/conclusion VS reject a statement/conclusion where they 'think' it is not correct? - Provide suggestions to improve a...

21 May 2020 2,624 7 View

What is the importance of social network analysis in research?

Beyond the beautiful lines or webs showing how connected an individual is, what other meaningful analysis could be done? for instance, are those directly connected the the individual more...

06 February 2020 5,574 3 View

Does EDC/NHS coupling act on primary amides or only primary amines?

I want to use a coupling reagent (possibly EDC/NHS) to link gold nanoparticles to primary amines and NOT primary amides. There are both primary amines and primary amides in my sample, but I want...

16 January 2020 7,378 4 View

How to calculate time needed to evacuate a pressure from a tank using a pump?

Dear I have an air reservoir with 50 bar pressure , this reservoir is fed by 2 bar air pressure source, I would like to instal air pump ( 30 m3/h ) to evacuate the 2 bar fed pressure so I always...

06 February 2021 3,520 3 View

Permeability of fractured reservoirs?

Hi all, What I know the permeability of matrix and fracture can be in a broad range in fractured reservoirs. Am looking for the most usual range for their permeability separately. I will be highly...

15 January 2021 5,271 2 View

Do you have some articles to recommend about comparative experimental study about gas and water flooding with oil reservoirs?

I would like to know in the oil extraction, which is more efficient: gas flooding or water flooding? Will water flooding be more efficient in hydrophilic reservoirs with capillary...

29 December 2020 3,471 3 View

How much the microbial exploration in oil and gas industry is applicable?

Microbial oil and gas prospecting (MPOG) I would grateful it if you could provide me with your invaluable comments and ideas on the following questions: 1- Do you consider MPOG as a promising...

15 December 2020 9,895 2 View

What is the current status of EOS modelling in unconventional reservoirs, esp. those with uplift and secondary migration of high-maturity gas?

Equation of state (EOS) modelling in CONVENTIONAL reservoirs is well established and has been successfully employed in PVT studies of basins globally for many years. However, what is the current...

12 November 2020 5,153 1 View

How to control variables in a water hammer experiment?

I'm doing a high school experiment on how the impulse of water hammer is affected by pipe diameter, and I'm unsure of how to set up my experiment. My primary concern is safety and validity: - Is...

06 September 2020 1,252 3 View

Fluid flow in fractured media?

Hey dear researchers, Am seeking some resources (no matter what kind e.g. thesis, book, article, and so on) explaining clearly equations governing the fluid flow in fractured reservoirs. I have so...

31 July 2020 6,196 9 View

What are the Criteria of Storing Natural Gas in Reservoirs?

Natural Gas can be stored underground in 4 types of reservoirs: 1- Depleted Gas 2- Depleted oil 3- Aquifer 4- Salt Cave. What are the criteria that help decide the suitablity of one reservoir for...

04 July 2020 3,329 4 View

Which website can provide inflow and outflow values for a reservoir in India?

Currently I am working on sedimentation assessment of Hirakud reservoir for this I need inflow and outflow values to calculate trap efficiency so can anyone suggest a website for retrieving these...

29 June 2020 6,530 1 View

Why do you not include geothermal science as a Research Area?

You provide a list of research topics including Geology, Geochemistry and Geophysics. However, many workers in the geothermal field specialise in the integration of the information from the above...

08 June 2020 9,616 4 View