In metals we can assume that Cp=Cv.
Are the Cp or Cv of solids highly pressure-dependent?
If so do they decrease or increase with applied pressure?
Thanks,
Aslan, maybe you can refer to a statistic physical book. I think cv decreases when you appliy pressure
I am trying to calculate the Inverse Pole Figure of a rolled sheet with BCC-like crystal structure. However, when I perform a tetha/2tetha scan I can only see 2 diffraction peaks (see attached...
31 December 2015 3,006 1 View
Is anyone familiar with wedge-type thin film multilayers fabrication? I need some basic information?
04 May 2015 8,559 2 View
Does anybody know how I can measure inverse pole figure from only 2 pole figures? According to standard technique in our XRD machine we need first 3 pole figures. Unfortunately, my material only...
04 May 2013 2,957 5 View
Approximate concentrations are require in compared with the WHO permissible limts
11 August 2024 2,723 1 View
I have modelled a steel structure using beam elements in Abaqus and attached to this structure reinforced concrete slab. The analysis that I am making is heat transfer of the structure. The...
07 August 2024 1,028 0 View
I have been getting a low plasma and no coating while doing rf sputtering of copper doped ZnS using a power of 140 watts and at pressure of 6.5x10-3 Mb.
07 August 2024 4,526 4 View
Hi! So i attempted to understand a novel protein behavior towards heat application by analyzing its secondary structure change. I subjected the protein to a thermal denaturation analysis using...
06 August 2024 1,989 3 View
Hello, I suspect that a molecule I am using is causing bacteria to experience osmotic shock. What chemical properties should I look for to compare this capability with those of other substances?...
06 August 2024 977 1 View
is there any other way to heat a polymer evenly other than oil bath if so what are those and how to use it
06 August 2024 947 1 View
I want to Estimate surface heat fluxes using MyLake, but I don't have all the initial values in model parameters section and other sections,is there a way?
04 August 2024 1,537 1 View
Reference dose and Maximum acceptable concentrations HMs
03 August 2024 8,230 4 View
A computational study of heat flux on cylindrical surfaces using CNT hybrid nanofluids
28 July 2024 4,985 1 View
I would like to conduct artificial sunlight experiments to mimic heat capture and air warming in a greenhouse system. The main objective is to heat up the temperature inside the greenhouse, not...
28 July 2024 4,006 2 View