Looking for research papers regarding concrete maturity. Could anyone share with me please?

15 January 2020 8,196 4 View

How to calculate the integration of plastic strain based on plastic strain components (PE) in ABAQUS/Explicit??

Hello, I would like to calculate the plastic strain increment = (max principle strain (3) - min principle strain (1)), which are taken from the plastic strain components (PE) and converted...

24 July 2019 5,296 1 View

What is the relationship between Sample concentration and Average count rate in Dynamic Light Scattering measurement ?

When I measure DLS for nanparticles size, I see that there are no rule in the samples concentration and the Average Count rate index in mine. I wonder that if the higher concentration of samples,...

12 January 2015 9,856 9 View

Sample dilution for quantitative analysis using ELISA?

If the detection range is in ng/ml but the reference range is in ug/ml for a molecule or protein in serum or plasma .how to dilute and what is the initial volume to be taken for quantitative analysis

02 March 2021 7,670 3 View

IF troubleshooting: looking at an intracellular protein that localizes to the cell's and how to reduce increase in signal due to cell ruffles?

I am currently trying to stain for PI3KBeta in MDA-MB-231 cells. My current issue is that 1) beta stains all over the cell and 2) there is an increase in signal at the edge of the cell and this...

24 February 2021 8,582 1 View

Is it efficient to do liquid biopsy to investigate the gene expressions of the tumor?

To do liquid biopsy and look for specific gene expressions there are so many published papers. Thera are different protocols and procedures used to isolate circulating cell free RNA or mRNA from...

23 February 2021 7,326 5 View

How to clean up TEM grid with plasma cleaner?

I need to clean the hydrocarbon contamination on the carbon substrate of TEM grid. However, I heard that substrate could be broken by the powerful plasma. My substrate is pure carbon, with ~3nm,...

23 February 2021 3,262 5 View

How we can measure Kemp % in wool without using of benzene?

Would you please let me to know about the methods for measurement of medullation and Kemp % on animal? My problem is that the wool sampling and sending to laboratory is not possible. So I would...

21 February 2021 7,260 4 View

No title

17 February 2021 4,217 3 View

What are the best cations for preparing competent cells, Ca2+ or Mg2+?

I have been reading various articles and most state that treatment with CaCl2 produces higher efficiency of transformation than MgCl2. Can anyone explain why Ca2+ is better than Mg2+ at...

16 February 2021 8,519 5 View

Differences between sheep blood with Alsever solution vs citrated/defibrinated sheep blood in microbiological media?

I am aware of a study that has compared the use of citrated and defibrinated sheep's blood in microbiological media (Hair Sheep Blood, Citrated or Defibrinated, Fulfills All Req... ), but can...

10 February 2021 5,927 1 View

How can I spin a thick layer of organic polymer?

I need to spin a 120um thick film. My current procedure consists of spinning the polymer (about 20um), uv exposure, plasma etch, and then spinning another 20um thick layer, uv again, plasma etch...

10 February 2021 2,055 6 View

What is the general miRNA yield one gets from the Qiagen miRNEASY serum/plasma advanced kit?

I am using the Qiagen miRNEASY serum/plasma advanced kit, using 400ul of frozen plasma. What is the yield you get on average? I am using nanodrop currently for quantification. I am getting...

02 February 2021 8,806 2 View