Are there any well known pitfalls/tricks?
I have tried a variety of remedies on the internet. From varying display properties on Yosemite, or font properties on Matlab. I tried a patch, unsuccessfully. I suspect it might be related to...
31 December 2014 7,010 3 View
I read about cryo-electron microscopy but the articles I could find were relatively old. And as someone out of the field I could not decide if this was really the current case. Any comments with...
05 June 2014 6,219 8 View
Note that it is not a footnote. And it needs to be one column in a two column document.
03 April 2014 5,807 3 View
I want to send a pencil beam of electrons onto a target. I am modifying the example B1 to get this. I do send electrons with defined energy and direction on to the given geometry via command line...
01 February 2014 3,681 9 View
I have a new macbook now and I can not decide if I should setup it from scratch or migrate the old one... Any ideas will be appreciated.
31 December 2013 1,658 0 View
Could you recommend some articles on Urban Transportation System optimization and Innovation?
13 August 2024 2,595 3 View
Require for Rietveld refinement in XRD.
08 August 2024 3,081 2 View
During low-temperature testing, new diffraction peaks that appear could be indicative of several phenomena. In one of our tests, we observed notable new peaks around 40° and 45° in a specific...
06 August 2024 726 3 View
I want to refine one XRD peak of my in-situ xrd but the background is never working good which ultimately fails the refinement. How to refine and adjust the background using GSAS-II
05 August 2024 5,291 2 View
How to calculate the molar proportions of the oxides from the XRF analyses?
02 August 2024 2,565 2 View
I fabricated Ti3C2Tx using concentrated HF 40%, I plot an XRD as attached image below.. please let to know if I obtained it or not.
02 August 2024 6,789 4 View
Hello everyone What is your opinion about the introduction of an expert decision support system in which the rules are extracted from existing data without human intervention, instead of being...
31 July 2024 5,785 4 View
What information we can get from PXRD analysis other than from SCXRD analysis of a crystal ?
30 July 2024 6,261 4 View
After a lot of feature engineering for click-through rate modeling, it feels like it's basically the end of iteration? I mean, it's not cost-effective to keep doing it?
29 July 2024 4,955 0 View
I am trying to run a restart analysis, which imports deformed configurations of parts from a generated ODB file. It runs fine in Windows OS but when I try to run it in Linux OS, it is giving some...
29 July 2024 9,572 3 View
