Is it possible to analyze the ratio of C12, C13 and C14 ratio using GC MS QTOF?

Vladislav Skrypai @Vladislav-Skrypai

27 March 2021 1 3K Report

Good time of day,

Is it possible to analyze the carbon isotope ratio using MS QTOF? Like for example, analysis of a CO2 sample?

Thanks!

Bojidarka B. Ivanova

Mr. Skrypai,

Yes, it is; furthermore, exactly in chemometric terms.

Please, consider detail on the following discussion. In particular, focus your attention on my comments on the issue and the reference section, therein.

[https://www.researchgate.net/post/Lipidomics_with_a_very_low_detection_What_to_do]

Badges
Science topic

More Vladislav Skrypai's questions See All

Does E-Voting matter for turnout, and to whom?

As a result of the use of internet-voting, voter turnout in the Swiss parliamentary elections in 2023 It was 46.6%, an increase of 2% compared to the previous elections, which were held without...

14 June 2024 5,548 1 View

What is a suitable software for controlling BioFlow 3000 Bioreactor?

Hello! I am conducting fermentation experiments using the BioFlow 3000 bioreactor. The manual says I should use the BioCommand Lite Software to control the bioreactor and collect data. However, I...

02 June 2024 6,505 5 View

How to optimize multiplex qPCR assay where two combined targets work poorly?

Dear researchers, I’m working on an Norovirus GI and GII qPCR assay with TaqMan probes. Recently, I experienced an issue with “multiplexing”. Briefly, the aim is to develop an assay for...

12 March 2024 4,844 0 View

Absorption spectrum of gaseous methane CH4 in UV range from 100 to 300 nm?

Dear Community, I'm looking for the information on absorption spectrum of gaseous methane CH4 in UV range from 100 to 300 nm, especially around 190 and 260 nm. If anyone have reliable...

23 January 2024 5,806 1 View

Can anyone assist in finding technical documentation for Fritz Heckert-EDZ100 universal test machine?

Hello, In our laboratory we started restoration of tensile/compression hydraulic press (Fritz Heckert-EDZ100 ) and for this purpose we need to find documentation for it. Any documentation will...

02 November 2023 4,712 1 View

What is the difference between behavioral models and surrogate models?

Both behavioral and surrogate models are used to establish a relationship between input and output parameters of a particular system or object. They enable the substitution of expensive modeling....

25 June 2023 3,952 0 View

Appropriate goodness-of-fit test for negative binomial regression?

I'm fitting a model in R where response variable is an over-dispersed count data, and where I meet an issue with goodness-of-fit test. As it has been previously discussed in Cross Validated,...

17 May 2023 2,161 1 View

Do I have any polymorphisms on my ISSR?

Hello. I just wondering if I have any polymorphic bands on these ISSR-PCR? And reasons for their absence. 'N' are control plants, and I don't see any difference between them and the last samples...

03 December 2022 5,005 3 View

How to measure the porosity of an etched surface using ImageJ?

How to measure the porosity without considering the inter-particle boundaries?

31 May 2022 8,744 7 View

How does reinforcement particle size affect the properties of cold sprayed composite coatings?

I was only able to find these articles. But there is no consensus yet. - K.I. Triantou D.I. Pantelis, V. Guipont, M. Jeandin Microstructure and tribological behavior of copper and composite...

24 April 2022 3,786 3 View

Which type of compound does lamda max of 218 indicate in a uv-vis spectrum of a partially purified compound through column and TLC?

A crude extract of fungal culture using EtOH was subjected to column and TLC and partially purified compound was obtained. UV vis spectrum of the compound/s has max absorbance at 218nm. The...

11 August 2024 9,801 2 View

Can you connect an HPLC to a Mass Spec only at a certain time point?

Can anyone explain this method? Especially the last statement where it says only at 1.5 to 2.5mins was the MS/MS connected to the UPLC. How is that possible, is it a feature in this specific...

11 August 2024 8,141 3 View

What is the reason for current dropping in OER , LSV curve?

I tried four trials of the same Copper Phosphides sample in Alkaline medium ( 0.5M KOH) with Hg/HgO reference electrode and Pt as counter electrode. I used 0.001 V/s scan rate for first three...

10 August 2024 3,629 1 View

Adhesion strength of coating?

How can I determine a good adhesion strength range for coatings on polymer surfaces, such as DLC on polymer substrates? Is there a specific threshold for adhesion strength (from T-peel tests)...

10 August 2024 942 3 View

Do interactions between biosphere, carbon cycle, & water cycle impact global warming & interaction between atmosphere & hydrosphere?

How do interactions between the biosphere, the carbon cycle, and the water cycle impact global warming and interaction between the atmosphere and the hydrosphere?

09 August 2024 3,291 2 View

GC-MS retention index prediticon?

Hello experts, Does anyone know any free software about retention index prediction ?

08 August 2024 7,403 2 View

How to calculate CCS for Sodiated adduct ions and Multiply Charged Ions?

I'm currently working on calculating the collision cross section (CCS) for various ions, and I'm facing challenges when dealing with sodiated and multiply charged ions. Most of the resources I’ve...

08 August 2024 8,329 0 View

Can I use a HisTRAP column for affinity chromatography?

I'm working on selecting antibodies against a recombinant protein that has a His-tag. My idea is to first bind the recombinant protein to a HisTRAP column and then use this column for an affinity...

07 August 2024 505 3 View

AUX gas reading problem on QE with full MS and PRM method in one run?

Dear QE-users, In the method where full MS positive mode and PRM mode are used, we always get an incorrect auxiliary gas reading (41 instead of 25). This only happens in this method; other...

06 August 2024 4,953 0 View

Who of all of you will help TPEOM to re-originate the Earths atmosphere to it original 5 atmospheric elements/gases?

Global ‘Weather’ has stopped, as ‘aqua thermionic instituted by the ‘Global thermo atmospherics has instituted global thermodynamics of 120º C + and thus all waters are, or have boiled into a...

06 August 2024 8,716 0 View