Is it any way separate vanadium from sulphuric acidic solution contains 10gpl V with 25 gpl of Al ?

Krishnan Muthukumar @Krishnan-Muthukumar

16 February 2024 0 3K Report

We are leaching vanadium from iron slag using sulphuric acid at 0.5 pH. The leaching liquor contains 9-11 gpl of vanadium along with 20 to 25 gpl of aluminum leaching and 2 gpl iron. What is the suitable solvent extraction method for vanadium selective extraction in the acidic solution? Pls drop your suggestions. thank you

Badges
Science topic

More Krishnan Muthukumar's questions See All

Why do we need to neutralize the charge of the system by adding ions before we proceed to energy minimization step in GROMACS ?

I am learning MD simulations using GROMACS and while I was doing a protein in water MD simulation a doubt raised. I was following the steps mentioned on the tutorials page and it said The system...

15 February 2021 5,514 4 View

Divergence detected in AMG solver for temperature and species , DEFINE_VR_RATE, Fluent ?

In 2D Model, Reaction in porous Zone, Error occurs on hooking UDF , DEFINE_VR_RATE in Fluent, .The error spikes just after running calculation after 1st iteration. Divergence detected in AMG...

16 November 2020 9,053 3 View

How to verify if a measuring system is working right?

We have 2 machines that test products. Both of these qualify the product to be Good or Bad ( Based on amount of leak ). The final outcome is attribute variable (Good/ Bad) whereas the way we...

16 November 2020 688 7 View

How to create a surface plot and contour? If i have an excel file with X, Y ,Z values of the surface ( Periphery of a tube) and Q (heat flux) value.?

Need to create 3d surface plot. Data I have X, Y ,Z coordinate of the pipe surface and the corresponding Q (heat flux) values at that point. Nearly 222440 data points of a 2m length pipe. Thank you

07 October 2020 9,854 7 View

Initialization in Fluent? Hybrid initialization or Standard initialization ?

Looking towards an incompressible flow (with K-e, turbulence model), with mass flow/velocity inlet and Pressure outlet boundary condition. Which initialization method preferred? How far it can...

05 October 2020 4,742 5 View

Why did it take humanity so long to start writing though we have been speaking for tens of thousands of years ?

They say we were just speaking and not writing anything for tens of thousands of years till a basic form of writing evolved just about ten thousand years back. Why this yawning gap ?

22 September 2020 5,313 7 View

Which is the best software to simulate chemistry of materials in correlation with their mechanical properties ?

ANSYS or ABAQUS donot correlate materials chemistry wirh the observed or simulated mechanical properties. Is there a software that can do this structure to property correlation. ?

22 September 2020 1,171 3 View

Is there any cost-effective, simple and efficient way to analyse and estimate the amount of vitamins in algal samples?

I am currently pursuing my research in Phycology. I'd like to know if there's any simple and cost-effective method to detect and analyze nutrients and vitamins in the algal matter. The experiment...

18 September 2020 4,081 3 View

Which research institutes in India have an algal identification facility?

I am currently pursuing my research in Phycology and planning to conduct a study on microalgae. Is there any place where I can send my samples to be identified? (Preferably in South India) Also,...

17 September 2020 4,440 2 View

How is the co-expressed genes regulatory network plotted? Is there any Bioinformatics tool for the same?

Hi, I am working on molecular validation of co-expressed genes in Rice under moisture stress. I have a list of genes that are co-expressed in three rice varieties, under a particular set of...

12 July 2020 7,494 1 View

What is the suitable range of Sulfur content and Viscosity of Heavy fluid Oil that used in Kiln?

What is the disadvantages of high sulfur content to the ceramic burning process? and what is the effect of outranged viscosity?

24 February 2021 8,219 2 View

About XRD details of pristine and doped RGO?

Hi Can anyone please help me know the XRD details of reduced graphene oxide, Nitrogen doped reduced graphene oxide, Sulphur doped reduced graphene oxide, Nitrogen and Sulphur co-doped reduced...

08 February 2021 3,033 3 View

What is the best visualisation solvent for xylooligosaccharides using TLC?

I am interested in using TLC to detect non-linear xylooligosaccharides. What would be the best visualisation solvent? Would aniline phthalate solution be suitable? I have also seen people...

02 February 2021 7,748 3 View

How to obtain V2O5?

Hi everyone! I`ve question about vanadium pentoxide. Exactly about precursors for the synthesis, about conditions. For example I need to obtain V2O5 powder, should I firstly obtain NH4VO3, or I...

11 January 2021 1,382 4 View

How to increase ductility of bitumen?

What's the optimum amount of sulfur or polyphosphoric acid that could add to bitumen for increase ductility without negative influence on viscosity and other parameters?

11 January 2021 985 4 View

Can we mix elemental powders of 325 mesh using an agate mortar and pestle?

Elemental Powders like Titanium, vanadium, tungsten, zirconium, hafnium.

04 January 2021 7,357 1 View

Which one is the most simple way to extract organic matter in sulfuric acid media? and how can I measure the content of them?

I have one solution which is dissolved Ni solution with sulfurc acid. Unfortunately our solution was contaminated with unknown organic matter. How can I extract and analyze unknow organic?

08 December 2020 8,699 8 View

How to calculate sulfur loading of lithium -sulfur batteries using Li2S8 catholyte?

I am gonna use Li2S8 catholyte to introduce active material to cathode instead of using sulfur. May anybody kindly guide me about the way I can calculate the amount of sulfur (g/cm2) loaded on the...

07 December 2020 7,556 2 View

ELISA plate losing colour?

I did a few ELISAs 3 days ago (six 96 well plates) and some of them (about 10) were positive. My detector was an HRP conjugated antibody and I used TMB substrate. I stopped the reaction with...

18 October 2020 8,234 2 View

Indoor and outdoor coronavirus concentrations in aerosols?

I have been wondering why there are so few studies that measure the concentration of coronavirus in the air, especially outdoor studies, so I started searching for reliable scientific...

28 September 2020 5,695 5 View