The default value for the peak search is 2.00, but the software does not detect any peak at this value.
i am unable to interpret why its increases in start as shown in figure
11 August 2024 2,179 1 View
How can I use the cif data obtained from rietveld refinement extracted via gsas2, for microstructural analysis using ETEX software?
09 August 2024 7,718 0 View
I have face this problem anyone help me how to solve this issue ?which is below Fatal error: There are inconsistent shifts over periodic boundaries in a molecule type consisting of 78 atoms. The...
07 August 2024 2,598 1 View
A Markov-like Model for Patient Progression" Markov Chain Monte Carlo (MCMC) Markov Chain Monte Carlo (MCMC) is a powerful computational technique used to draw samples from a probability...
05 August 2024 10,079 0 View
Hello, I'm looking to dissolve soy lecithin in order to create a liposome. I've tried using various solvents like pure ethanol, methanol, and a mixture of ethanol and methanol but they didn't...
02 August 2024 6,980 4 View
It is important to highlight that technological surveillance on oceanographic vessels is a collaborative effort in which different specialists work together to effectively leverage technology in...
31 July 2024 1,633 0 View
I am currently working on modeling FCC catalyst regeneration and have come across a point of uncertainty that I hope you can assist me with. In my previous models, I have utilized lumped kinetics...
30 July 2024 6,137 0 View
I'm a PhD Student. From Northwest Agriculture and Forestry University China. My Problem is this I start my work on bhlh79 transcription factor gene. I do my Y2H 5 time but the colonies appear on...
30 July 2024 1,412 8 View
I am seeking a PhD position in the area of Deep Learning, specifically in generative AI. Cn anyone of you help me finding a suitable supervisor open for a PhD candidate.
28 July 2024 1,849 1 View
Kao's panel cointegration tests , is there anyone willing to explain me the eviews-9 output for the Kao's panel cointegration tests?
23 July 2024 5,051 4 View
I oxidized MWCNTs using HNO3 and dried it in oven a month back. Can I use this to make a CNT composite or does CNT looses its properties after a while if not used immediately? It is sealed in an...
26 June 2022 245 6 View
I'm planning to work on Graphene nanotubes in the field of defence/warfare. Looking for suggestions.
06 December 2021 3,988 4 View
Attached I have some pictures of carbon nanotube that I produced with a coldwall CVD tank with ethanol vapour. Vacuum level was 250 pascals (not that low). Hot surface was a graphite plate around...
14 September 2021 2,386 8 View
I am looking for an alternate 2d hydrocarbon material that can be used alongside CNT as a hybrid material to design a membrane or supercapacitor.
25 July 2021 3,046 4 View
cnt manufacturing from graphene
01 July 2020 839 5 View
I would like to prepare a solution of CNF/IPA but is there any other solvent better for CNF dispersion? What weight ratio it should be? Is there any suggestion for dispersion method? Thanks
08 September 2019 6,494 2 View
Dear Researchers, I am trying to work with CNT/Al composites through powder metallurgy and gone through literature which says functionalization of CNT with -OOH group make better dispersion of...
26 June 2019 2,629 2 View
05 June 2019 6,573 3 View
If I prepare, for example, PDMS nanocomposite with 40wt% or 50wt% MWCNT, what will happen to the electrical conductivity values of this nanocomposite?
10 January 2019 5,010 4 View
Several methods are available like Ultrasonication, calendering method etc.. Which is the best technique to achieve homogeneous dispersion of carbon nano-tubes in order to obtain maximum...
21 December 2018 3,913 3 View