How to approach CFD simulation results of a flow past a cylinder?

Hi all, I'm doing a transient simulation of flow past a rectangular cylinder close to the free surface. As far as I'm concerned, the common practice is to discard the initial stages of the...

25 February 2021 1,348 3 View

How to calculate time-averaged fields from Ansys CFX solver?

I would appreciate any comments on the following problem. I need to calculate mean fields (e.g. pressure, velocity and vorticity), for which I activate Trn Stats tab in CFX-Pre. However, what I...

21 February 2021 8,548 7 View

The most suitable turbulent models to predict flow past a floating body?

Hi all, I'm planning to simulate flow past a floating body using CFD method with the main purpose of investigating its stability against hydrodynamic forces. A sketch of the problem is presented...

28 January 2021 5,872 5 View

Stable region for VL model?

29 December 2020 4,125 3 View

How can I fix the capacity curve of two different structure?

I have two frames for nonlinear analysis, one of them is CBFs and one of them is BRBFs ( the generals are the same, only lateral elements are different). When I drew the capacity curve of my...

11 November 2020 10,034 3 View

How to measure the equivalent sand-grain roughness of a sandpaper?

I want to use standard sandpapers of different grit sizes to impart flow resistance to a surface. I am wondering how to convert the roughness of sandpaper to an equivalent sand-grain roughness. Is...

18 October 2020 9,384 3 View

How to calculate transvers current correlation function (MD)?

12 October 2020 4,424 1 View

How can I obtain thermal efficiency in thermal photovoltaic (PVT) systems by CFD (FLUENT) method ?

Hi everyone I have a question about the thermal efficiency of photovoltaic thermal (PVT) system by CFD (FLUENT) method. Why thermal efficiency in the morning with 400 W/m2 radiation is more than...

13 September 2020 2,543 4 View

How to deal with ANSYS Q3D surface mesh generation error?

I am trying to extract the stray inductance of a PCB bus bar using ANSYS Q3D. I tried different types of meshes but every time in the middle of the simulation, this error "Surface Mesh Generation...

10 September 2020 2,060 3 View

How can I improve Reinforcement Learning Agent training?

Hello everyone, I am trying to develop an RL agent for a simple double integrator system. Unfortunately, my agent couldn't find the maximum reward. The attached figure is the average episode...

20 July 2020 6,159 4 View

How to compare two groups with only two measurements?

Hiiiii everyone! I have an enquiry on statistical analysis. I was looking for many forum and it's still cannot solve my problem. I want to compare means of two groups of data but only with two...

03 March 2021 8,796 3 View

Resistor definition in Piezoelectric bimorph with ANSYS workbench

Hello, good day! I am trying to simulate similar bimorph piezoelectric harvester with below commands. However, the output power doesn't change with resistor value. Please help to find the reason. ET,10,CIRCU94,0 !SET UP RESISTOR R,1,100000 !RESISTANCE VALUE TYPE,10 !SET ELEMENT TYPE E,1,2 !CREATE RESISTOR BETWEEN NODES 1 AND 2 Thanks in advance Regards,

02 March 2021 0 0 View

How to access MSCI KLD Stats and Sustainalytics?

Hello all, I'm currently working on my undergraduate thesis and I'm having difficulties trying to access KLD Stats and Sustainalytics because my campus Airlangga University and apparently other...

02 March 2021 8,525 1 View

Which of the Covid-19 Vaccines would elicit the best immunoprotection and why?

I want to know which of the available Covid-19 Vaccines would elicit the best immunological response and why

02 March 2021 1,388 3 View

How to code open-ended questions in SPSS?

Hello all, In SPSS I am going to code 2 open-ended questions. I have already read all the answers and I made a list of the most important categories to which I can code the answers. This question...

02 March 2021 1,757 4 View

What analysis to choose with a large neste dataset and clearly skewed or kurtotic distributions?

Hello! I have a dataset of n=3000 nested within 8 countries with approximately 200 or 400 responses in each country. I originally planned to perform multilevel modelling with 4 dependent variables...

02 March 2021 6,865 1 View

Do you know any MR image dataset?

I would like to research on MR images (0.5T and 3T). Can you please suggest some websites that I can download dataset including both 0.5T and 3T MR images? Thank you.

02 March 2021 7,735 3 View

How to eliminate Steady state error from Reinforcement learning genetic algorithm code?

The following code (see 1st 2 images attached) is used to produce PID controller values that are designed to control the system (G). The code finds the PID controller values (noted as k) by using...

28 February 2021 6,560 14 View

Which is better medicine or food in obesity?

Preference in terms of the scientific aspect

28 February 2021 796 2 View

Where can I find public datasets with Covid-19 patient information?

Hi, I'm looking for public datasets that have CT, X-ray information, or medical records for patients with Covid-19. Does anyone have suggestions?

28 February 2021 4,760 3 View