List of journals in optics and laser ?

Dear colleagues,Could you please suggest me some rapid publication ISI journal list in Optics, Crystal growth, laser with good impact factor (rapid publication)? and have scopus , thomson reuters...

01 February 2018 5,405 2 View

Can we prepare a thin film of unknown concentration?

I have an unknown concentration of Chemical solution, can we prepare a thin film from it.

01 February 2018 2,419 0 View

Can you suggest some articles for a better understanding of the basic methods for preparing a sensor?

I'm looking for articles that will give me understanding on the methods of preparing a sensor.

31 December 2017 8,992 0 View

Which one of the laser dyes can produce second harmonic generation?

Anyone have an idea about the laser dyes that produced the SHG.

31 December 2017 4,754 0 View

What are the conditions that effected on the polymer ?

what are the conditions that effected on the polymer ?

08 September 2017 6,803 0 View

What are the different between the Q-switching and the frequency doubler by the electro optical photonics crystals?

03 April 2017 7,407 1 View

How can I minimized the walk off rays during the Q-Switching operation by LBO crystal ?

01 January 1970 8,677 6 View

What is the optical method to measure the thickness of the sample (thin film , polymer and crystal)?

I want to know about the optical method to measure the thickness of the sample (thin film, polymer, and crystal)? and what is the parameter that we need to measure it?

01 January 1970 8,630 2 View

What are the most important applications of second-harmonic generation (frequency doubling)?

In additional to converts the light of one particular angular frequency to light at exactly double that frequency so the wavelength is halved.

01 January 1970 6,227 0 View

Is there another method (not the Z-scan technique) to measurement the nonlinear optical properties of crystals?

I want to learn a new method to measurement the nonlinear optical properties of crystals .

01 January 1970 9,400 2 View

1 nm thick MgO thin-film to be deposited on Si wafer using thermal evaporation. What will be the optimum deposition conditions?

Favourable conditions of base pressure, rate of deposition. Also, by which characterisation technique to be used to verify the thickness of the deposited film.

28 February 2021 3,640 3 View

Gas sensor response and recovery time independant of flow rate and chamber volume?

I am trying to obtain the response and recovery times for my gas sensor device. It appears the the response/recovery times are primarily dependant on the flow rate of the gas I inject into the...

26 February 2021 1,511 3 View

How to prepare a thin polymer film by post-polymerization/crosslinking?

24 February 2021 2,362 5 View

Is is possible to pole with corona poling pellets of the sample material instead of thin films?

As it is highly probable that pellets will have a higher degree of air gaps and voids than thin films, is it possible to pole the samples with corona poling nevertheless? Or is there the...

24 February 2021 1,349 1 View

How to troubleshoot Electrochromic Films and Electrochromic Devices?

I am trying to characterize an electrochromic system. The system uses ITO electrodes on glass, WO3 as the electrochromic film, and NiO as the ion storage layer. When I deposit NiO and WO3 and...

23 February 2021 9,592 2 View

How to improve the adhesion between germanium and silicon monoxide thin film layers using EBEAM evaporation?

I want to deposit multilayer coating of germanium and silicon monoxide on silicon wafer using ebeam evaporation?

21 February 2021 2,141 3 View

How can I measure the thickness of thin layers deposited on textured glass susbtrates?

I want to measure the thickness of aluminum oxide and titanium oxide layers deposited on textured glass substates. The layer thicknesses are typically below 100nm.

21 February 2021 5,465 4 View

How do I calculate absorption coefficient of my thin film if I dont know the thickness? Or how can I calculate the thickness of my sample?

I have done Uv-vis characterisation of my thin film and have received absorbance and transmittance data. Now I want to calculate the absorption coefficient but I dont know the thickness of my...

21 February 2021 7,148 8 View

Open Source IoT Simulators supported by Machine Learning?

Dear Research Gaters, Let me first add context to the question. I am looking to simulate the waste management system and resources of a city. The hardware devices I need to simulate include,...

21 February 2021 2,333 4 View

How to construct different filler shape in MD simulations?

Is there any way to construct different initial filler shapes like triangle, square, rectangle, pillar, and tube in any simulation software.

20 February 2021 1,750 1 View