No DNA pellet after air drying?

After drying my DNA samples for 20mins under a Bunsen at room temperature I can't see any pellet and no DNA shows up on a gel, despite having pellet in the previous step (precipitation, washing...

08 November 2020 7,775 2 View

How to culture of keratinocytes from human skin punch biopsy?

Hi, I have been having problems culturing keratinocytes from 4mm human skin punch biopsies. When I recieve the biopsy I first was the samples in sterile PBS, then I remove the subcutaneous fat. I...

24 April 2020 2,696 2 View

What are the possible indels generated when NHEJ is activated via CRISPR Cas9?

Hi, So I've got the bi-allelic sequence of several Knock Out cell lines I've generated. I assume that the mutations have been caused by NHEJ after the DS break by Cas9. There is variation in the...

02 February 2020 2,212 2 View

Recent papers on the multiplicity/complexity of routine goals including the use of goal theory in routines?

Hi - can anyone recommend recent papers on the multiplicity/complexity of routine goals including the use of goal theory in routines? D'Adderio notes the absence of goal theory but I'm using it as...

01 January 1970 8,654 3 View

Why does blocking with my immunogenic peptide cause nuclear fluorescence in ICC?

Hi all, I am validating a polyclonal antibody raised against human ANT4, through WB and ICC. In most of my controls, the antibody shows very little off-target binding, but when I pre-incubate the...

03 March 2021 5,999 3 View

No title

02 March 2021 3,060 3 View

Issues with Permeabilization during Flow Cytometry?

Hello Everyone. Currently I am working to characterize macrophages in the myocardium after ischemia-reperfusion injury in rats. Due to the low total cell number isolated from rat hearts I can...

01 March 2021 3,867 3 View

Timeout error!! Processor in the loop (PIL) using STM32F4 Matlab 2018a?

Dear Researchers I am trying to perform a PIL simulation using STM32F4 Discovery board and comunication serial USB TO TTL. During simulation I receive the following timeout error: An error...

01 March 2021 2,327 1 View

Which cell line should we use to perform biological dosimetry experiments?

We are preparing some experiments based on irradiating cells under different conditions in order to evaluate the effects in terms of DNA damage, genetic expression, etc. As our project is...

01 March 2021 3,355 3 View

Is it possible for two human neuronal cell lines to have different gene sequence for the same protein?

I am looking at the ATP1A2 (Sodium/Potassium ATPase alpha subunit 2) in two human neuronal cell lines. Expression levels of this protein seems to be almost equal when detected by one antibody....

01 March 2021 3,607 3 View

Is CD44 degraded in lysosome together with hyaluronan after CD44 mediated endocytosis of hyaluronic acid?

Also when RHAMM binds hyaluronic acid, they get internalized, will RHAMM also be degraded? Or both CD44 and RHAMM will be transferred back to the cell membrane? Asking for breast cancer cell line...

01 March 2021 8,169 2 View

Do you need the CMV enhancer before the CMV promotor for a proper function of CMV on the gene that follows?

I'm a student and I have to produce a cell line with a knockin for the NRF2 gene with GFP. I have to put a promotor in front of the GFP because the gene will be too far away from the promotor of...

28 February 2021 7,127 2 View

What could be some reasons why unstimulated monocytes are getting activated?

Im doing PBMC isolation -> CD14+ enrichment using magnetic beads -> stimulation setup. My negative control is just cells in cRPMI but they seem to get activated over and over again.

28 February 2021 7,883 3 View

What is the ideal efficiency for a qPCR?

hello everyone, I need to do standard curves for my qPCR, what is the ideal efficiency range? I tried a primer (Mglu2 receptor) that gave an efficiency of 90.2%. Is it accepted?

28 February 2021 1,254 3 View