I want to take UV spectra of film but the blank is not a film it is in small pieces so how i could perform the blank ?
should i dissolve both blank and sample in an appropriate solvent and then read the spectra ?
If you dissolve the film then you're not measuring a spectrum of the film, you're measuring the film dissolved in solvent. You should probably measure in diffuse reflectance geometry and use spectralon as your "100%R" sample.
During low-temperature testing, new diffraction peaks that appear could be indicative of several phenomena. In one of our tests, we observed notable new peaks around 40° and 45° in a specific...
06 August 2024 726 3 View
Hello all, I have been trying to follow a 2-stage PCR protocol used to amplify barcodes of a large yeast library, as per Nyugen et al. (2022) -...
30 July 2024 841 2 View
When I run autogrid4 it says: autogrid4: ERROR: Unknown receptor type: "Cr" -- Add parameters for it to the parameter library first! Look forward to your reply.Thank you so much!
29 July 2024 488 0 View
Hello everyone, I am facing a consistent issue in my NMR spectra with an unwanted peak appearing at 1.25 ppm. This peak seems to vary with the amount of sample: it becomes more pronounced with...
15 July 2024 9,065 4 View
I'd like to know if anyone has got experience in intracerebroventricular (ICV) AAV inj. I am looking for a concomitant spread of the AAV including but not limited to the motor cortex and the...
12 July 2024 781 0 View
Solid state NMR study
03 July 2024 422 1 View
I am trying to eliminate infection from my plates and therefore, gave UV treatment after addition of amino acid (used for better growth). Can you please suggest if UV destroys amino acids or not,...
02 July 2024 2,922 1 View
Kindly provide their URLs. Thank you
30 June 2024 8,475 0 View
I have been working in Hanoi University of Public Health. I would like to know where and how I can buy AMOS software?
28 June 2024 6,593 1 View
I am working on a small signal stability analysis of a power system on a power electronic load. The power electronic load is modeled as a voltage-dependent load and has the relation attached in...
26 June 2024 2,496 1 View
For example, I perform passivation process before electropolymerization of Py for adhesion to titanium surface. Is a similar or different procedure required for ITO? If necessary, I would be glad...
06 August 2024 3,176 0 View
I'm using a InVia Renishaw Raman microscope system (785nm wavelength, 600l/mm grating density) to acquire Raman images on human brain samples, at 50um resolution. The samples are placed on MgF2...
30 July 2024 8,771 3 View
Dear all, I have noticed, as the ZnO content increases, the Raman intensity at 100cm-1 also increases. However, there is a peak nearby at 130 cm-1, which I could not find in any paper related to...
28 July 2024 5,410 1 View
I have images of film formed on the bottom of a 50mL beaker, and I have been trying to figure out the surface area. I could easily use features on imageJ to do that, but I want to know which area...
23 July 2024 4,461 1 View
These datasets will be used in the training of machine learning algorithms. Does anyone know any available data?"
17 July 2024 6,519 3 View
Dear all, I'm currently working with CHI potentiostat and performing Impedance. However, for the circuit fitting the instrument must be connected to the computer. Since I prefer to analyse the...
10 July 2024 8,880 4 View
I am trying to measure the plasmon resonance angle of gold film and pure water using the Kretschmann configuration and a 633nm laser. Without flowing water over the gold, I can detect a clear...
10 July 2024 4,719 3 View
I have to compare the FTIR of the two samples, one is in powder form and other one is the powder dispersed in IPA or water. Both are same material, so how the bond will change
09 July 2024 8,011 2 View
In order to make a polyaniline film, I used the electrodeposition method and set all the conditions, but I noticed that the polymerization process is happening, but it doesn't stick to the...
09 July 2024 2,708 2 View
I'm currently analyzing the Raman spectra of coloured plastic samples and have encountered a wavy, oscillating pattern in the spectra of some coloured samples. I was wondering what the possible...
04 July 2024 1,949 4 View