I need information on the P4508 propeller, preferably a 3D model if possible.
As the title described, it is common that a target gene sequence contains motif that acts as the binding site of transcription factor rather then the upstream regulatory region. Does this affect...
13 May 2024 1,099 3 View
As title describes, we're trying to mutate an amino acid of antibody Fc to cysteine, followed by TCEP to further drug conjugation, one of my colleague had raise the concern of purified TCEP...
29 April 2024 3,227 2 View
Do the atomic orbitals of the same atom have the same energy under different chemical conditions? In other words, can atomic orbital energy be changed by external changes? For example, does...
22 April 2024 6,055 1 View
Different metals have different adsorption and activation abilities for different small molecules (such as N2, CO2). What are the properties of the met
16 April 2024 836 2 View
What properties determine the ability of different valence metals to adsorb and activate small molecules (such as CO2, N2)?
16 April 2024 9,282 4 View
How to select the good sample rate for bearing fault diagnosis using the vibration measurement. for example in my case shaft speed is 30 Hz. by Nyquist Frequency = 2.56 times greater than the...
25 March 2024 3,471 2 View
Please help me. I conducted a cell proliferation experiment, continuously diluted threefold from 10000nM to 1.5nM, and processed the data using Prism. Why is it that the fitted IC50 value cannot...
23 December 2023 2,117 2 View
I have the bearing fault diagnosis experimental vibration data with acoustic for a healthy and different fault conditions with different speeds. I want to use the ML algorithm, but before that, I...
07 December 2023 967 1 View
My lab co-worker need a lot of T cell for his animal experiment, however one of the donor can't provide enough for downstream analyses, we thought to combine purified T cells from two donors in...
06 November 2023 7,188 0 View
Three weeks after the establishment of xenograft tumor model (CDX model), there is fluid in the tumor of mice, and some of it will flow out. What is the cause?
08 July 2023 7,161 1 View
I have virus (viral hemorrhagic septicemia virus) in suspension and the experiment will not involve cells. What level of TCID50 is preferred?
11 August 2024 3,115 1 View
I am developing a predictive model for a water supply network that involves 20 influencing points. However, I only have historical data for 10 out of these 20 points. I would like to know how to...
10 August 2024 4,005 2 View
Usually, additive manufacturing techniques like SEBM, SLS, and SLM are used for interconnected porous lattice structure generation with sizes of >100–200 micrometers. Can the Fused Deposition...
09 August 2024 7,892 0 View
I need to model an anisotropic material in which the Poisson's ratio ν_12 ≠ ν_21 and so on. Therefore, the elastic compliance matrix wouldn't be a symmetric one. In ANSYS APDL, for TB,ANEL...
09 August 2024 5,048 2 View
I am trying to simulate vehicular loading on an orthotopic steel deck bridge section in ABAQUS software. The red arrow mark in the attached figure indicates the direction in which the vehicle will...
08 August 2024 719 0 View
Dear fellow researchers, I am currently working on a paper where I need to provide a reliable reference that defines and distinguishes between 3D mesh models and 3D city models. Although I am...
06 August 2024 9,986 2 View
I am working on Abaqus/Explicit(Quasistatic ) for the deformation of the auxetic structure model. Please explain how the plastic input value should be considered from the true stress-strain curve...
05 August 2024 454 3 View
I am seeking experimental or applicable data for the liner (LLDPE) interface in FLAC3D numerical modeling of a large stockpile. Could you please recommend suitable references? The preferred data...
05 August 2024 3,665 0 View
I am working on a SEM model where i have 7 latent variables (6 exogenous and 1 endogenous). In AMOS when I co-vary the exogenous constructs, only 2 paths are coming significant out of 6. But when...
03 August 2024 6,028 4 View
AI-driven technologies offer previously unheard-of capabilities to process enormous volumes of data, extract insightful knowledge and improve predictive models, according to the UN’s World...
31 July 2024 9,733 3 View
