I need a research lab

06 June 2014 0 6K Report

I need a nanofluid research lab to carry experimentation on heat transfer inflow through a tube.

Badges
Science topic

More Nnorom Obinichi's questions See All

I need a research lab

My name is Ezekwem Chidozie from Nigeria. I am currently carrying out my doctoral studies in the Department of Mechanical, University of Ibadan, Nigeria in the area of Nanofluids. My research is...

09 October 2014 1,478 0 View

Can anyone help me with mesh generation?

I am carrying out a simulation of fluid flow using helical pipes using ANSYS Fluent. I am having problems with how to get the optimum mesh and also with how to carry out a mesh independent study....

05 June 2014 7,212 10 View

Can anyone help with grid independence study?

I need a good explanation on how to perform a grid independence study. I am currently using ansys fluent 14 to simulate nanofluid flow in a helical pipe.

05 June 2014 4,598 5 View

How can I analyze two phase nanofluid modelling using Ansys Fluent?

I am trying to analyze nanofluids numerically using mixture and Eulerian model using Ansys Fluent 14. Can you please render assistance on how to simulate nanofluid flow using these models?

05 June 2014 5,830 9 View

MD MOE RMSD

How to calculate the RMSD values for a MD simulation using MOE?

07 August 2021 0 0 View

MD MOE RMSD

How to calculate the RMSD values for a MD simulation using MOE?

07 August 2021 0 0 View

fatal error

When I tried to energy minimization my system, I got fatal error as below. Fatal error: Atomtype opls_116 not found Although I've already added this line: ; include water #include "oplsaa.ff/spc.itp" to [molecultype] directive in my topology.

16 June 2021 0 0 View

fatal error

16 June 2021 0 0 View

fatal error

16 June 2021 0 0 View

fatal error

16 June 2021 0 0 View

Resistor definition in Piezoelectric bimorph with ANSYS workbench

Hello, good day! I am trying to simulate similar bimorph piezoelectric harvester with below commands. However, the output power doesn't change with resistor value. Please help to find the reason. ET,10,CIRCU94,0 !SET UP RESISTOR R,1,100000 !RESISTANCE VALUE TYPE,10 !SET ELEMENT TYPE E,1,2 !CREATE RESISTOR BETWEEN NODES 1 AND 2 Thanks in advance Regards,

02 March 2021 0 0 View

Arena simulation - how do i model the following model in ARENA (see description) (new to ARENA)?

Hello, I'm fairly new to ARENA and I have the following problem: I have two queues in which, in each queue, a different order type arrives (both having an arrival rate of exponential 10). Order...

02 March 2021 2,431 3 View

Why are the velocities so high in my Boussinesq approximation Fluent simulation?

Hello, I have a mechanism where air rises due to convective flows. In this simulation, nothing is driving the air except this. I understand that the Boussinesq approximation only works for small...

02 March 2021 4,910 3 View

What is the characteristic length to determine the Reynolds number for the scattered turbulent fluid flow?

Dear all, I just saw this example in FB on the difference between laminar flow and turbulent flow. The flow from a pipe hits the sink and scattered. The flow from the pipe is characterized as...

02 March 2021 1,999 5 View