the error is showing as following while running a job.
The elements contained in element set ErrElemExcessDistortion-Step1 have distorted excessively.
Print-out suppressed for subsequent distorted elements
There are a total of 20 excessively distorted elements
The ratio of deformation speed to wave speed exceeds 1.0000 in at least one element. This usually indicates an error with the model definition. Additional diagnostic information may be found in the message file.
The elements contained in element set ErrElemExcessDistortion-Step1 have distorted excessively.
Abaqus/Explicit Analysis exited with an error - Please see the status file for possible error messages if the file exists.
Try to use the reverse method to identify the cause of the error.
Simplify the model as much as possible.
Reduce the rotation speed. Is this error still there?
this error is resolved but i am not getting temperature in the results .
- Badges
- Science topic