Is there any effective FEM solver to perform simulation of balloon inflation with large deformation (e.g. 300% strain)?

Hi! Thank you for your time, attention, and support. I am currently using FEM solver Abaqus to perform a set of balloon inflation simulations, trying to understand the deformation shape, stress,...

14 February 2021 2,524 4 View

Why are we measuring gel content of NBR latex? Does gel content related to the amount of cross-linked in a polymer?

Hi good day to everyone! I am actually studying the gel content of synthetic latex. Refer to ASTM 3616, gel content is measure of insoluble rubbers in the chosen solvent. So, I just would like to...

07 February 2021 605 4 View

How to delete a copy of a paper, and how to delete a co-author's name?

I mistakenly uploaded a copy of the same paper and entered my alternative name. How to delete them out? (I couldn't navigate to the right buttons to do it. So from where to where is what I don't...

07 January 2021 7,694 6 View

What effect will different solvents have on the ATRP reaction?

I want to do an ATRP reaction, synthesize an ATRP initiator, use DMF as a solvent, and mix DMF, BIBB and TEA to turn red. Why does it turn red? Xylene has been used as a solvent before, and there...

04 January 2021 8,034 3 View

Is it possible that the phosphorylated proteins mobilize faster than the non-phosphorylated ones?

The band downshifts on Western-blot, after kinase assay treatment.

23 December 2020 7,959 3 View

Species identification.Who can tell me the scientific names of these Gastropods?

Species identification. I've been doing research on communities of marine macrobenthos recently, but some of them can't be identified, which hinders my research. Who can help me identify these...

14 December 2020 8,357 3 View

Cell shrinkage during ROS assay(H2DCFDA)?

Hi! I'm Yu, studying about health of MSC. These days, I'm doing ROS assay with H2DCFDA which requires 5~30 minutes of staining with PBS or HEPES or HBSS. In our lab, We use PBS w/o Mg/Ca for...

13 December 2020 8,813 9 View

Can I fix the cells after H2DCFDA assay for FACS analysis?

Hi ! I'm Yu, and planning to analyze ROS assay with H2DCFDA(Thermo) on MSCs. A lot of protocols instruct that treat H2DCFDA at specific concentration for 5~30 min, 20~30 min of recovery time...

10 December 2020 973 1 View

How to reconstruct a Lamb wave by a series of pulses superposed?

Lamb wave is useful for solid structure health monitoring, and it consists many modes. Unlike ultrasonic bulk wave, when given a pulse excitation (for example, 5-cycle sinusoidal pulse), only...

08 December 2020 5,440 8 View

How to interpret the significant effect of covariates when conducting a Two-way ANCOVA?

06 December 2020 8,560 4 View

How can I integrate a routing protocol in a tiny device (e.g. Raspberry Pi)?

Hi Community, I'm facing the issue of integration/compiling a new routing protocol in a WSN simulator. The final goal is to successfully add, configure this routing protocol in hardware devices...

01 March 2021 9,332 6 View

How to improve and implement WBAN MAC and Radio modules under Castalia 3.2 ?

Hello researchers, Hello Castalia3.2 researchers I am a beginner with Castalia, I work on optimization of RFID systems used in wireless body networks. I simulated a WBAN with 10 nodes and one...

28 February 2021 400 1 View

D2D implementation in Matlab in Vienna LTE software?

Hi Hope you are well. Can you please share your code for D2D implementation in Matlab. I want to implement D2D in Matlab based Vienna simulator and struggling to deploy D2D. Thanks

24 February 2021 9,378 3 View

What software programs can directly simulate Additive Manufacturing Directed Energy Deposition (DED)?

I understand there are a lot of software programs that can simulate DED by going through specific modeling, simulation, and commands. For me, that was time consuming and results were not accurate....

24 February 2021 4,428 3 View

Is it possible to set a breakpoint at a specific DYNAMIC instruction using the GNU Debugger (GDB)?

Using GDB, it is straightforward to debug and monitor a target program by setting a break-point at a specific instruction, since the instruction addresses are known. However, we have two...

24 February 2021 1,598 2 View

Langevin Dynamics in shear flow?

Hi, We are trying to simulate particles with Langevin dynamics in a shear flow by Lees-Edwards boundary conditions in MD simulations. It seems thermal forces and shear flow do not go hand in...

23 February 2021 1,761 1 View

Should I use Pressure Based Solver or a Density-Based Solver?

Dear researchers, I want to simulate a flow (air) in a wind tunnel, and I want to integrate a fluidic actuator inside it in order to control the separation of the boundary layer. At the blower...

22 February 2021 4,882 3 View

How to simulate 5G Quality of Service characteristics?

For my research, I would like to simulate an end to end 5G network. My goal is to observe the behaviour of SDAP protocol, dynamic configuration of 5QI values etc. To summarize I would like to...

21 February 2021 7,624 3 View

Open Source IoT Simulators supported by Machine Learning?

Dear Research Gaters, Let me first add context to the question. I am looking to simulate the waste management system and resources of a city. The hardware devices I need to simulate include,...

21 February 2021 2,333 4 View

How can I simulate the optical absorption spectrum of a biomaterial (like DNA or protein) in COMSOL?

I need to simulate the optical properties of a biomaterial, namely DNA, in COMSOL. Basically I need to simulate the IR absorption spectrum of a cylinder filled with a 'concentration' of DNA. I am...

21 February 2021 3,043 3 View