How to remove Zn from aluminium turnings?

07 September 2020 1 8K Report

And what will be the reaction?

Zinc can be removed from the aluminum turning . A lance is used to blow argon gas into the turning melt which reduces the partial pressure of zinc, leading to the evaporation of zinc from the melt.

Badges
Science topic

More Pallavi Deshmukh's questions See All

Absorption coefficient of methane?

Hello, Can anyone provide me with the absorption coefficient of methane gas at 7.7 um? Any reference?

06 August 2024 980 5 View

How are Large Models Exploring and Outputting Knowledge Understanding in Specific Content Areas, and What Does Academic Research Say About It?

Hello everyone！ I am currently exploring the performance of large models in understanding knowledge in specific domains, and attempting to construct a knowledge framework similar to what...

05 August 2024 5,729 2 View

Regarding a model for simulating battery charge and discharge, what do you consider to be high fidelity?

Regarding a model for simulating battery charge and discharge, what do you consider to be high fidelity? What is the acceptable percentage of error (regardless of the metric)? Could you suggest...

03 August 2024 5,358 0 View

How do i get an account to upload my published papers?

need to open an account to upload my published papers

01 August 2024 9,255 1 View

What is the problem with these tissue culture plants?

All plants are green but some of these plants becomes yellow. I did not found any reason. Please help me to find out the real problem.

01 August 2024 589 4 View

How to correctly use the UTE and ZTE pulse sequences in Bruker's ParaVision software?

I am using a Bruker 600M solid-state NMR spectrometer with a Micro 2.5 microimaging system. The test sample is a tube of 1M LiCl aqueous solution, and the nucleus detected is 1H. I am trying to...

01 August 2024 9,227 1 View

Is artifacts in XPS possible to build high deviation in binding energy larger than 5 eV??

Hello. Thanks for your consideration to see my question. Recently, I conducted XPS anaylsis of g-CN that is prepared from thermal polycondensation of DCDA, so-called conventional bulk-g-CN,...

30 July 2024 9,824 2 View

Which statistical test should we use?

N=6 Comparing pre and post test likert scale responses. Participants are mix of practicing & preservice teachers.

30 July 2024 7,233 4 View

How to build my own lab made four point probe set up?

Hello, I'm trying to measure the conductivity of semiconductor films but since I don't have a commercial four point probe set up I would like to build one on my own in my lab. I have generators,...

30 July 2024 906 2 View

Can the limit of quantification (LOQ) of an analytical method fall outside its linear dynamic range, or must it always be within it?

Can an analytical method's limit of quantification (LOQ) be outside its linear dynamic range, or is it always required to be within it? Please provide a thorough explanation supported by verified...

29 July 2024 7,198 9 View

How can the rubber fibres produced by the electrospinning device be removed from the fibre collect(aluminium foil) ?

How can the rubber fibres produced by the electrospinning device be removed from the fibre collector (aluminium foil) without affecting the orientation of the rubber fibres for use in reinforcing...

26 July 2024 8,281 0 View

How to remove DDQ from bodipy reaction only possible colmun chomatography tecnique use here ?

bodipy moiety are high polar nature .so its are bottom of TLC PALTE up to 20;80(ethyl acetate;hexane) mixture so its binding in SiO2 SO YIELD is so decreased. how to remove DDQ from reaction mixture?

02 July 2024 8,846 4 View

How to calculate the proportions in grams or milliliters of the compounds for 60 mL of SAPO-11 zeolite precursor gel?

It is required to make a precursor gel for a SAPO-11 Zeolite, the compounds are the following: * As a source of Al: Aluminum Isopropoxide (98%) Formula: C9 H21 O3 Al PM: 204.24 g/mol Density:...

01 July 2024 617 3 View

How to remove aluminium oxide from powder ?

I synthesise intermetallic compounds through nickel and aluminium powders. But the pure powder after synthesis is difficult to obtain. Especially the presence of aluminium oxide very seriously...

01 July 2024 4,030 3 View

Can I use aluminium acetate basic instead of aluminium acetate to synthesis iron oxide nanoparticle through hydrothermal method?

My idea was to prepare discal shaped iron-oxide using Al3+ metal-ion mediated solution to regulate the morphology of of my nanoparticles, but most literature uses aluminium acetate and not...

22 June 2024 6,136 2 View

Metal film diffuses through SiO2 and reaches Si substrate?

I deposited a 50-nm-thick Pt film on a silicon substrate using magnetron sputtering method. TEM results showed the presence of SiO2 layer between Pt and Si-sub. Strangely, between SiO2 and...

06 May 2024 531 3 View

Is depositing SiO2 on PDMS through sputerring/PECVD for hydrophilicity a good idea?

I am making PDMS flexible microfluidics and would like to deposit SiO2 onto the microchannels to make them hydrophilic for longer (since plasma treatments only last a few hours at best). I've...

24 April 2024 585 1 View

Why is the hydrothermally prepared MoS2 nanoflower not adhering properly to the SiO2 substrate and not making proper contact with the electrode?

I have prepared MoS2 using a hydrothermal approach and then dropcasted it onto a SiO2 substrate. However, it is not adhering to the electrode and does not make proper contact, resulting in no...

02 April 2024 6,151 0 View

How efficiently and without any defects, MOFs can be coated on metals like Aluminium or Copper?

How MOFs like MIL 101 (Cr), ZIF, and UiO 66 be incorporated on metals via spin, spray, or electrochemically? Is any particular literature available?

27 March 2024 5,128 2 View

Does 0.2 (M) ammonium oxalate-oxalic acid (pH 3.25) reagent extract poorly crystalline Mn-oxides too?

Besides extracting the poorly crystalline Fe- and Al-(hydroxy)oxides, does 0.2 (M) ammonium oxalate-oxalic acid (pH 3.25) buffer extract poorly crystalline Mn-oxides too?

05 March 2024 4,841 2 View