bcoz copper nanoparticles often get oxidised even at room temp.
See the following link and cross references:
http://dx.doi.org/10.4236/ojapps.2013.35043
bcoz pH affects the size of the nanoparticles.
31 December 2016 9,797 4 View
given B.P of n butanol is 119 C and flash point of butanol is 80 C REQIRED B.P for butanol is 230 C and flash point required is 110 where as flash point of dietylene glycol is 145C and B.P of...
04 May 2016 6,947 8 View
I am not getting pure copper nanoparticles, rather copper oxide is more formed.
04 May 2016 4,747 5 View
becoz different morphology has different property
02 March 2016 2,982 2 View
yield is very low in case of copper sulphate
01 February 2016 8,320 2 View
most of the plant have antioxidative property
01 February 2016 744 0 View
some paper reported taking just after mixing some reported after drying
01 February 2016 8,427 5 View
I am doing the synthesis of nanoparticles where papers report to incubate the reaction mixture for 12 hours at 60 degree C.
31 December 2015 4,794 0 View
It is reported that when higher concentrations of noble metal salts in comparison to the bio-reducing agents inhibit successful synthesis of the nanoparticles further it was reported that when...
11 December 2015 1,676 5 View
The pH of the medium affects the size and distribution of the nanoparticles. At low pH, coalescing occurs forming larger nanoparticles while at high pH value small nanoparticles are formed.
11 December 2015 4,317 5 View
I have been doing the m6A dot blot for a while with no improvement, I am extracting the RNA, and I can see the dots although the three biological replicas give a different reading on the memberan...
10 August 2024 8,539 5 View
I am using Rhodamine6G as gain medium and silver nanoparticles as scatterers on a microscope slide and laser input 532 nm comes from above.
09 August 2024 9,894 2 View
How can I use the cif data obtained from rietveld refinement extracted via gsas2, for microstructural analysis using ETEX software?
09 August 2024 7,718 0 View
A fungal strain was treated with nanoparticles. We want to do an environmental SEM analysis. So could anyone share your views on preparing the sample? Thank you.
07 August 2024 5,307 1 View
I have been getting a low plasma and no coating while doing rf sputtering of copper doped ZnS using a power of 140 watts and at pressure of 6.5x10-3 Mb.
07 August 2024 4,526 4 View
How do soil microflora interact with plant roots and influence plant nutrition, health, and productivity?
06 August 2024 9,618 3 View
Palmitic acid presence in aqueous fraction
05 August 2024 8,624 4 View
I am interested to know the behavior of dyes toward light. Specifically, Blue dyes re-emit the spectrum, especially from the green zone (known as principal in LED lamps, and blue dyes are known...
05 August 2024 3,290 1 View
I have been using paraffin, but the deposited ZnO still detach from electrode. What is the best binder to modify graphite paste electrode with ZnO nanoparticles?
03 August 2024 4,624 3 View
I work on MCF7 cell cell for anticaner purpose and I wa to do drug preperation the drug ( secondary metabolites extracted from Aspergillus) My question which solvent is better with these secodary...
03 August 2024 4,725 2 View