How to plot a hardness mapping reading using origin software?

More Ahmad Muhammad Aziz's questions See All

Using OBD technique i am trying to measure laser induced shockwaves velocity i found that at start velocity increases and then decay?

i am unable to interpret why its increases in start as shown in figure

11 August 2024 2,179 1 View

Gromacs first step of minimization ?

I have face this problem anyone help me how to solve this issue ?which is below Fatal error: There are inconsistent shifts over periodic boundaries in a molecule type consisting of 78 atoms. The...

07 August 2024 2,598 1 View

"A Markov-like Model for Patient Progression"?

A Markov-like Model for Patient Progression" Markov Chain Monte Carlo (MCMC) Markov Chain Monte Carlo (MCMC) is a powerful computational technique used to draw samples from a probability...

05 August 2024 10,079 0 View

Question about combustion Kinetics ?

I am currently working on modeling FCC catalyst regeneration and have come across a point of uncertainty that I hope you can assist me with. In my previous models, I have utilized lumped kinetics...

30 July 2024 6,137 0 View

How to we see transcription activity of the bhlh79 family is at the N-terminal or C-terminal?

I'm a PhD Student. From Northwest Agriculture and Forestry University China. My Problem is this I start my work on bhlh79 transcription factor gene. I do my Y2H 5 time but the colonies appear on...

30 July 2024 1,412 8 View

How apply Kao Residual Cointegration Test in eviews?

Kao's panel cointegration tests , is there anyone willing to explain me the eviews-9 output for the Kao's panel cointegration tests?

23 July 2024 5,051 4 View

What is the principle/mechanism behind aging of carbon (graphite) containing refractory mix for isostatically pressed refractories?

The resin bonded carbon containing refractories are aged before use. How time of aging is determined? And mechanism behind aging.

23 July 2024 3,205 0 View

When I am trying to distill triethyl amine while drying it over calcium hydride. How do I design the setup to let hydrogen escape without losing NEt3?

I am new to research. The boiling point of triethyl amine (NEt3) is 89 degrees centigrade. I am skeptical that when I will let the hydrogen escape which is getting generated in situ, I will also...

21 July 2024 7,284 4 View

What is the suitable solvent of MIL-100 for chemotherapy?

I synthesised a nanocarrier by conjugation MOF (MIL-100) with folic acid for use in chemotherapy but the samples didn't dissolve completely in aqueous solution or DMSO. Instead, they only...

19 July 2024 8,522 0 View

Why my gel electrophoresis have shadow bands? Please see the attached picture for the gel electrophoresis ?

Sometimes I see the shadow like bands and its not true band. I want to know that what's the reason for it. I am using 2% gel for running genotyping samples I have uploaded the gel picture in both...

19 July 2024 148 6 View

Can formaldehyd-fixed gelatin be melt?

I am puzzled about the properties of gelatin, when used for tissue-embedding. Hard gelatin can be melt again by temperatures about 40°C. Formalin-fixed gelatin is like crosslinked protein and...

07 August 2024 1,686 1 View

Why am I getting "shark finn"-like signal?

My collegue and I are having hard time to understand what is happening. Basically we have a tapping device that work with Arduino and a pneumatic pump. The pump allows the tapping of two...

04 August 2024 4,662 1 View

In SEM, if a latent variable consists of three observed variables, and each observed variable has four items, what should I do?

Suppose I am studying the construct of "Academic Motivation" (latent variable) in students, which is measured through three observed variables: "Intrinsic Motivation," "Extrinsic Motivation," and...

31 July 2024 3,913 6 View

How can I get old refernce in geomorphological mapping?

how can I read Waters, R. S. 1958. Morphological mapping. Geography 43 :10-17 from internet? note: not in google or resaearch gate

26 July 2024 7,813 3 View

How to merge two or more linkage maps?

I have three linkage maps that needs to be integrated to create a consensus map for QTL mapping.

25 July 2024 6,505 2 View

Mechanochemistry: ball to powder mass or ball to powder volume?

I run mechanochemical reactions that involves the use of a large amount of catalyst (1:1 molar ratio to the reactant). When I try to understand the effect of amount of catalyst on the reaction, I...

23 July 2024 9,938 1 View

Enquire about the calculation of percentage of reads mapped to the reference sequence?

Hello researchers, I have sequenced the A549 cell line using RNA sequencing approach and then I have it against the human genome reference sequence. Would I expect a 100% mapping percent? I got...

20 July 2024 9,705 0 View

How can I determine if a drug binds to a ribosome using a Cryo-EM map?

Hello, I am searching for the binding position of a drug in a ribosome, based on previous work indicating it binds there. The resolution of the ribosome-drug Cryo-EM map is around 2.5 Å. I've been...

19 July 2024 2,155 0 View

Are the coordinates the center of the cell or a corner in GADM / worldclim maps in R?

I am currently using a map downloaded from https://gadm.org/maps/DEU/bayern.html and I would like to assign the value of a variable to each cell with R. I was also trying to get this information...

15 July 2024 8,844 1 View

how does the mass spec fraternity handles peptide map of PEGylated proteins ?

I would like to do peptide map of a protein which is attached to PEG via lysines. Now the best approach would be to de-PEGylate it but then do the peptide map. But there is little literature on...

14 July 2024 5,634 2 View