I have Fluorescent Polystyrene beads. I need to graft PEG on the surface of it. I am looking for a protocol to do that. Also need to know which experiment to perform to be sure about the grating.
I have the following equation, Eating choice (Yes/No)~ Box type (A/B/C). So the question is whether a certain box type affects eating choice in groups of dogs. The eating choice of each member in...
10 February 2021 6,024 9 View
what kind of test can I do for testing the level of knowledge about their daily operation?
03 February 2021 7,583 10 View
The observed bandgaps are 3.8 eV and 3.4 eV for spin-coated and electrospun films, respectively. What are the possible reasons?
08 January 2021 5,646 6 View
I want to know the reaction mechanism of monoethanol amine used as flocculating agent for rerefining used lubricating oil. Here I have attached one research paper where MEA (monoethanolamine) is...
01 January 2021 5,681 2 View
18 December 2020 4,559 6 View
I am a junior research fellow in the department of Chemical Engineering, Nit Durgapur. I want to know that how can I determine various metal such as Fe, Cr, Mg, Mn, Pb concentration present in...
15 December 2020 9,887 3 View
In O 1s spectra, usually the peak near 531 eV belongs to oxygen vacancy sites in oxides, however, in silicates, these peaks are often reported to originate from O-Si. I am confused if the intense...
10 December 2020 9,496 2 View
Hi, I am trying to find out the mol. weight of GFP 11 because it is tagged to my protein of interest which is 17kDa. GFP 11 has been tagged with my protein of interest while GFP 1-10 is tagged...
09 December 2020 1,863 1 View
I am conducting a regression discontinuity design where the dependent variable is continuous while control variables are categorical (except the treatment variable). In the usual regression...
01 December 2020 583 3 View
24 November 2020 1,318 8 View
Is There Any Feasible Method To Test The Efficiency Of Fluorescent Compounds Other Than UV Spectrometers ? Suggestions Would Be Appreciated !
02 March 2021 5,785 3 View
Hi all, I have been working on the quantification of chitin in insect samples and feed for a while but I can notice that the quantification methods (e.g. exposure to HCl, NaOH, and weighing sample...
01 March 2021 1,843 2 View
I am growing the cells on coverslips and transfecting the fluorescent tagged protein directly on them. Then i want to observe these cells under confocal microscope. Currently i am just using...
01 March 2021 6,142 3 View
Is there any reason for decrease in fluorescence emission intensity of HSA,BSA when increase the concentration ?
28 February 2021 3,653 4 View
Hi, all! I need to determine if my treatment causes membrane damage in bacteria (S. aureus and E. cloacae), but I cannot use a fluorescent probe such as PI and similar ones because my compound is...
24 February 2021 2,006 2 View
I am planning to perform a degranulation assay using CD107a antibody. Some resources suggest to use inhibitors like monensin to inhibit the intracellular traficking and acidification of the...
21 February 2021 6,260 3 View
I'm developing a UHPLC assay, and the fluorescent product is 2,3-dihydroxyquinoxaline. The reaction to produce this requires hydrochloric acid (about 1.2 M). Will storage in this acidic...
20 February 2021 5,820 4 View
Hello, i work with a spectrometer which only render the fluorescence emission spectrum. Until now i just found how to interpret an exitation- and emission spectrum together to generate deeper...
20 February 2021 1,291 3 View
I'm using blast furnace slag for stabilizing subgrade soil.
17 February 2021 7,333 3 View
Dear all, I'm trying to understand if a molecule of my interest (capable of inducing glucose-stimulated insulin secretion) determines an increase in intracellular calcium levels in the presence of...
16 February 2021 453 2 View