Created a single stage speed reducer in Adams view. Applied a constant torque on input gear. After simulation, plotted the torque vs time for output shaft. But torque curve is fluctuating not a constant one. As per theory the output torque must be gear ratio times the input torque. I'm not getting it in adams view
Hi Nantha Kishore
You can easily add a sensor to your model by using the "Measure" in Adams/view. If this isn't the case, I suggest you download the " Adams Tutorial Kit for Mechanical Engineering Courses". It's very comprehensive and you might find your answer in it.
In addition, the " Torque-Pendulum Tutorial - MSC Software" is also a good brief tutorial.
Cheers
There is a glitch. Input motion should not contain input torque. Apply torque on other gear. Then, See the results. I think this will sort your problem.@Nantha Kishore
- Badges
- Science topic
- Similar topics
- Engineering
- Mechanical Engineering