Dear folks,
I am working on C13 labeled glucose TCA cycle. Please explain how to calculate M+1, M+2, M+3, M+4…….. enrichment. Thank you!
Dear Naga,
first, you have to convert your mass isotopomer distribution (MID) data in a summed fractional labeling (SFL) as described here:
Article Metabolic Network Analysis of Bacillus clausii on Minimal an...
Chapter Metabolic Activity Profiling by 13C Tracer Experiments and M...
Make sure that you correct your GC-MS data for natural isotope abundance prior to calculation:
Article Correcting mass isotopomer distributions for naturally occur...
Finally, you can calculate the 13C enrichment in % depending on the 13C enrichment of the glucose tracer used (see paper above).
Regards
Michael
Take into account that not all GC/MS fulfill the specification for these type of analysis. The best HRMS, but some normal MS has enough resolution and discimination if the enrichment it is higher.
Regards,
Eleuterio
Please look at the following below links which may help you in your analysis:
https://www.ncbi.nlm.nih.gov/pmc/articles/PMC5192448/pdf/metabolites-06-00042.pdf
https://orbilu.uni.lu/bitstream/10993/34841/1/metabolites-08-00015.pdf
Thanks
Thank you very much!!
a man was facing a paralysis problem.. he wants some drink or else food not even he ask, because he paralyzed .while he put the smart spectacles he blinks the eyes it will count the sensors and...
13 July 2024 8,021 1 View
i havea custom message class(Custom.msg) file with content message Custom { float xPos; float yPos; }...
12 February 2024 1,546 0 View
I'm looking for a dataset that explores Ayurvedic health, including diseases, remedies, and formulations. The data should include information on traditional practices, herbal ingredients,...
09 November 2023 2,488 1 View
We are planning to use an q-exactive mass spectrometer for top-down proteomics . There is an HCD collision cell in mass spectrometry. How well does q-exactive's top-down proteomics work?
18 October 2023 8,352 1 View
I am modeling a powder bed by using finite element method, In the mechanical behavior of the the powder particles depend on the friction between the particles and the sliding movent with blade.
11 October 2023 4,071 1 View
I am modeling the phase change material in FEM, initially the material is solid state,and the heat supplied by laser scan on the top surface, due this heat source of the model get transform form...
11 September 2023 4,193 2 View
I am trying to model the residual stress in the body, which is subjected high temperature gradients. In the process of cooling/solidification the residual stresses are formed in the member. I red...
06 September 2023 6,483 2 View
??
16 June 2023 1,534 1 View
The following feature has encountered a problem: - Feature: Dependent Variables 1 (sol1/v1)Solution 1 (sol1) is not computed
29 May 2023 781 1 View
Who can provide me with the full version of ISO 6964 standard ISO 6964 Polyolefin pipes and fittings — Determination of carbon black content by calcination and pyrolysis — Test method
27 May 2023 8,845 0 View
A crude extract of fungal culture using EtOH was subjected to column and TLC and partially purified compound was obtained. UV vis spectrum of the compound/s has max absorbance at 218nm. The...
11 August 2024 9,801 2 View
Can anyone explain this method? Especially the last statement where it says only at 1.5 to 2.5mins was the MS/MS connected to the UPLC. How is that possible, is it a feature in this specific...
11 August 2024 8,141 3 View
I tried four trials of the same Copper Phosphides sample in Alkaline medium ( 0.5M KOH) with Hg/HgO reference electrode and Pt as counter electrode. I used 0.001 V/s scan rate for first three...
10 August 2024 3,629 1 View
How can I determine a good adhesion strength range for coatings on polymer surfaces, such as DLC on polymer substrates? Is there a specific threshold for adhesion strength (from T-peel tests)...
10 August 2024 942 3 View
How do interactions between the biosphere, the carbon cycle, and the water cycle impact global warming and interaction between the atmosphere and the hydrosphere?
09 August 2024 3,291 2 View
Hello experts, Does anyone know any free software about retention index prediction ?
08 August 2024 7,403 2 View
How is energy cycled through the Earth's climate system and how do matter cycle and energy flow through the rock cycle?
08 August 2024 8,162 0 View
I'm currently working on calculating the collision cross section (CCS) for various ions, and I'm facing challenges when dealing with sodiated and multiply charged ions. Most of the resources I’ve...
08 August 2024 8,329 0 View
I'm working on selecting antibodies against a recombinant protein that has a His-tag. My idea is to first bind the recombinant protein to a HisTRAP column and then use this column for an affinity...
07 August 2024 505 3 View
Dear QE-users, In the method where full MS positive mode and PRM mode are used, we always get an incorrect auxiliary gas reading (41 instead of 25). This only happens in this method; other...
06 August 2024 4,953 0 View