Hello all, I modeled a simple torque on a shaft. The results should be linear but my contour plot shows the change to have only occurred through the first element of the shaft and not the entire shaft. The values of the output (UR, UR3) are correct, but the contour plot of the whole shaft should reflect the linear change seen in the legend not just the first element. I plotted the angle of twist along a path of nodes which confirms the increasing angle of twist is linear. Is there a way to get the contour plot to reflect this more accurately? The contour plot of the shaft should show the green color around the middle of the shaft, where the angle of twist is half the value of the max. Any thoughts? Kind regards,
RP
- Badges
- Science topic
- Similar topics
- Cognitive Science
- Thinking
More Ron Perrone's questions See All
Similar questions and discussions