I am trying to make a full cell where I am using LTO as anode material and LCO as cathode material and 1M LiPF6 IN EC/DEC as electrolyte. How to calculate the energy density and capacity of the cell? I need a discussion on electrochemical procedure. Thanks in advance.
Before any prediction/calculation[1], about the energy density and capacity of the full cell, you need to find, as a first-priority, these quantities, for each one of your own electrode materials; so, start studying on your own, both of their[2], corresponding, (your) half-cells[1-3].
1. See table1, in "Li-ion battery materials: present and future" https://www.sciencedirect.com/science/article/pii/S1369702114004118
2. See: 3.3 Cell assembly [page18]; however, use Cu, as current collector, in "Lithium titanate as anode material in lithium-ion batteries" https://www.diva-portal.org/smash/get/diva2:873630/FULLTEXT01.pdf
3. See: 2.4. Electrochemical measurements, in "Lithium Cobalt Oxide as Lithium Ion Battery Cathode Materials..." http://www.abechem.com/No.%201-2018/2018,%2010(1),%201-17.pdf
Before any prediction/calculation[1], about the energy density and capacity of the full cell, you need to find, as a first-priority, these quantities, for each one of your own electrode materials; so, start studying on your own, both of their[2], corresponding, (your) half-cells[1-3].
1. See table1, in "Li-ion battery materials: present and future" https://www.sciencedirect.com/science/article/pii/S1369702114004118
2. See: 3.3 Cell assembly [page18]; however, use Cu, as current collector, in "Lithium titanate as anode material in lithium-ion batteries" https://www.diva-portal.org/smash/get/diva2:873630/FULLTEXT01.pdf
3. See: 2.4. Electrochemical measurements, in "Lithium Cobalt Oxide as Lithium Ion Battery Cathode Materials..." http://www.abechem.com/No.%201-2018/2018,%2010(1),%201-17.pdf
- Badges
- Science topic
- Similar topics
- Engineering
- Electrical Engineering
- Electrodes