I did a MCA analysis using FactoMineR. I know how to interpret cos2, contributions and coordinates, but I don't know how values of v.test should be interpreted.
Thank you
hi Josep,
these two might help with the interpretation
http://www.sthda.com/english/wiki/multiple-correspondence-analysis-essentials-interpretation-and-application-to-investigate-the-associations-between-categories-of-multiple-qualitative-variables-r-software-and-data-mining
https://groups.google.com/forum/#!topic/factominer-users/55w8gvADWJo
cheers, Kostas
Hi Josep,
I use SPAD to perform the MCA and i only look to the contributions that have more than value-test higher than 2.0.
Best regards
I found this which explains everything .. in French: http://www.deenov.com/Data/Sites/1/docs/Valeur-Test-critere-de-caracterisation-statistique.pdf
BTW you're supposed to look at c.test only for supplementary variables.
Hi, I want to deposit a metallic film (~800nm, sputtering, evaporation...) on top of a FTO glass to improve the conductivity of the substrate. The substrate will face temperatures of 500 ºC for 2h...
11 January 2022 6,458 8 View
If there is, I need info on -The effectiveness of these ultrasound method compare to palpation. -Where I can get the equipment and few suggestion.
08 November 2021 2,839 2 View
Hi, I'd like to measure the C-H bonds in graphene oxide in suspension in any liquid but can't find a solvent with very small absorption to that ~3000cm-1 region. Do you think there is...
28 October 2021 7,347 3 View
How I can run RM using Mixed model in SPSS with 2 or three wave data?
02 June 2021 7,683 9 View
Hello everyone, I've been co-culturing hiPSC-derived Ngn2 neurons with human fetal astrocytes, and at the time of grabbing the coverslip from the plate (24 wp) the cells peel off the coverslip. I...
03 September 2020 3,154 1 View
I'm using Gini coefficient and Lorenz Curve plots to show the accumulation of beneficiaries in ecosystem services (ES) supply points, in R. I classify ES into three categories and calculate Gini...
28 April 2020 4,405 3 View
I have a dataset with distances between beneficiaries and the nearest provision point (nearest hub). I want to develop a model to explain distances based on several atrributes like category of...
05 April 2020 8,467 10 View
Does anyone know about any supplier for DARPP-32(Thr34) antibodies that work well in immunofluorescence? Specifically to prove in mouse and rat tissue.
01 February 2020 4,171 1 View
The problem must be the definition of the output string, because I tried the same code but writing a route directly on the parameters list and it worked. This is the code I wrote: import...
07 August 2019 6,424 4 View
Dears, I developed a travel cost model comparing data which was collected before and after an ecological restoration. The aim is to determine if the restoration affected the recreational value of...
25 September 2018 7,658 1 View
I would like to learn more about SPSS and Its application especially in regards to data analysis. Please suggest me how I can learn more about it. Thank you so much.
11 August 2024 9,101 4 View
I have reverse sequences (AB1 format), can I base on reverse DNA sequences to perform nucleotide alignment, convert nucleotides to amino acids and deposit the sequence in GenBank database?
11 August 2024 5,138 1 View
Hello, Why do i see this baseline drift when i compare my blank (black) to the sample (blue)? Any suggestions as to why this happened? Thank you!
11 August 2024 3,770 4 View
Willett, Shenoy et al. (2021) have developed a brain computer interface (BCI) that used neural signal collected from the hand area of the motor cortex (area M1) of a paralyzed patient. The...
10 August 2024 7,180 0 View
I am developing a predictive model for a water supply network that involves 20 influencing points. However, I only have historical data for 10 out of these 20 points. I would like to know how to...
10 August 2024 4,005 2 View
I'm currently exploring the application of Python in textile engineering, specifically in areas like data analysis, process automation, and the development of smart textiles. I'm interested in...
10 August 2024 7,429 2 View
How can I use the cif data obtained from rietveld refinement extracted via gsas2, for microstructural analysis using ETEX software?
09 August 2024 7,718 0 View
Let's say we have a standard, regular hexagonal honeycomb with a 3-arm primitive unit cell (something like the figure attached; the figure is only representative and not drawn to scale). The...
07 August 2024 1,937 1 View
A fungal strain was treated with nanoparticles. We want to do an environmental SEM analysis. So could anyone share your views on preparing the sample? Thank you.
07 August 2024 5,307 1 View
Hi, I have a question about normalizing the MTT OD values for doing the statistical analysis. So, if we have 3 different plates and we call them 3 different replicates, so, first we would...
07 August 2024 8,106 4 View