I found the following problems when importing Word forms into AI software:

1. Copying a finished Word form directly inside the AI software, the AI software has problems and quits for no reason.

2. so I will Word form first converted to PDF format, and then use the AI software to open the PDF form, you can open.

The current problem is:

Word converted PDF form each word or number is a single character, rather than a whole. For example, "Control" the word, in the AI software is C o n t r o l 7 individual characters, rather than Control a whole. The same number of similar problems, such as "322.23 ± 0.25" is not a whole, but 11 characters. This leads to a big problem when I zoom in and out of words or numbers, "Control" cannot be zoomed in and out as a whole, but rather as 7 individual characters.

Figure 1 below shows the normal Control as a whole;

Figure 2 shows Control as a single character;

Figure 3 shows "Control" as 7 separate characters.