I have created stator blades and rotor blades by using coordinates and used SolidWorks. However, I tried to create fluid volumes for those blades, to simulate in CFX and have not achieved yet. I need to generate the following kind of Fluid volume. I have tried Bladegen. But it doesn't facilitate blade creating from given coordinates. Hence, the fluid volume couldn't generate through it.
Could you please give me some insights on this?
Have you tried to read your Solidworks CAD into either one of the ANSYS Geometry Modelers - ANSYS Design Modeler or SpaceClaim? Both should be able to extract the Fluid Volume from your CAD geometry. Than you could pass the resulting Fluid Volume e.g. inside Workbench to one of the available meshers (ICEM/CFD, ANSYS Meshing (not recommended for Turbo so),...).
Regards,
Dr. Th. Frank.
First you should model the blade in CAD software. then you should model all volume contains blade and fluid. then subtract all volume from blades. the remained volume are Fluid volumes.
- Badges
- Science topic