How to find the torque needed to pull a linear force?

26 August 2022 1 599 Report

I need to know the motor torque that can provide me a clamp force of 98N using a cable pulley mechanism as shown below in the figure. Any suggestion on how should I should approach to tackle this problem?

Regards,

Sameed.

Badges
Science topic

Similar topics
Analytical Chemistry
Column

In frequency domain alpha band(8-16hz), beta band(16-32hz), gamma band(32-64hz), sub-band(64-128hz) are same as LL,LH,HL,HH in wavelet decomposition?

I am working on single trial motor imagery data i.e. EEG data. I am following a paper which has a dataset from BCI challenge IV (dataset 2b). After removing noise and extracting all the data from...

23 February 2021 5,503 1 View

Suppose we have a banana seller cart consisting of 4 wheels, weighing about 300 kg. How much torque motors are needed to pull of push it electrically?

I am thinking of electrifying the street food carts while harvesting energy using solar panels on top.

22 February 2021 4,323 3 View

Can you please suggest me how to convert EDF file into Mat file for EEG datasets?

Hi sir, 1.can you please suggest to me how to convert the EDF (European Data format) file into a Mat(Matlab) file for EEG datasets?. 2. Also suggest some publicly available EEG Motor Imagery...

15 February 2021 7,620 1 View

Is Genetic Algorithm usage for Motor Conception FEA optimization a good choice?

Hi RG community, Like the title shows ,i was wondering if choosing the GA for this kind of Optimizaiton is a good choice? For example we have a population of 100 (for 7-8 Optimization Variables),...

14 February 2021 1,160 7 View

How to interface ANSYS Maxwell and Matlab?

Dear All, I am working on electric motor design in Ansys Maxwell. I have written optimization code in MATLAB. I want to run this code in ANSYS MAXWELL and generate FEA results. Does anyone know...

10 February 2021 1,279 1 View

How can I prevent my switching power supply from sudden voltage increases ?

Hi Everybody, I'm currently using a 3kW AC/DC converter which gave 48VDC output(Switch mode power supply). The device is capable to deliver up to 62.5A current to the load. My application is a...

08 February 2021 7,642 4 View

Can downdraft gasifier for RDF be scaled up?

Dear researchers, In literature, so far I am seeing that downdraft is usually used for small-scale purposes (10kW-10MW). One of the reasons behind is "they do not allow for uniform distribution...

08 February 2021 5,403 1 View

How to obtain the plot of frequency shift w.r.t. pressure in a micro resonator (cc beam) based MEMS pressure sensor in COMSOL?

I need to know how to plot the impact of pressure (0 - 100 kPa) (which is applied on the back side of diaphragm) on the frequency shift caused in the cc beam supported on the diaphragm with...

01 February 2021 5,805 17 View

Can I project all raw motor imagery EEG data onto two spatial filters developed from training data?

Greetings RG community, I have been working on a pipeline for the classification of EEG motor imagery signals. This is currently being done on the Giga Science MI dataset with 52 subjects, using...

28 January 2021 6,947 2 View

Can someone explain blocking vs. nonblocking electrodes in terms of electrochemical impedance spectroscopy?

I have fabricated thin films and want to measure the impedance parallel to the material. I suspect the films are conducting protons and electrons based on some Hall effect measurements I have...

27 January 2021 1,712 5 View