I am referring to optical parameters like permittivity and refractive index
Thanks Arian
can anyone help me about refractive index of multilayer graphene in optical wavelength?thanks
05 June 2016 3,844 5 View
Is it right when doping of graphene increased, its relaxation time decreased? if there is a formula, let me know about that.
07 August 2014 5,848 4 View
Looking for optical parameters (like permittivity or refractive index) of p-doped Si. I checked refractiveindex.info and Palik's book but found nothing.
02 March 2014 8,973 3 View
I need a book or article which could explain in details this theory for graphene.
09 October 2013 894 4 View
Is there any formula to explain the fermi energy of graphene?
09 October 2013 3,511 4 View
I fabricated a pt-porous si schottky diode as a gas sensor. Adjacent to NO2 or NO gases I expected to have a low breakdown voltage (in constant current) or high current (in constant voltage) due...
08 September 2013 275 6 View
If we model FET by source, gate and drain capacitors, when strain is applied how will its capacity will change?
08 September 2013 8,491 3 View
In order to simulate nanowire ZnO based devices, I want to use effective DOS of both electron and hole. I also need its electron affinity. Unfortunately I could not find any thing about mentioned...
08 September 2013 5,277 3 View
I want to apply it in continuity equation
07 August 2013 3,528 3 View
Papers just talk about graphene surface horizontal mobility but what about its vertical mobility? (I mean perpendicular to its surface) Does it play an important role in bipolar transistor?
04 May 2013 2,224 10 View
I’m trying to reproduce the acousto-optic coupling simulation in the paper Frequency–angular resolving LiDAR using chip-scale acousto-optic beam steering. LNOI(lithium niobate on insulator) is...
13 August 2024 9,795 0 View
I fabricated Ti3C2Tx using concentrated HF 40%, I plot an XRD as attached image below.. please let to know if I obtained it or not.
02 August 2024 6,789 4 View
I'm researching light sources and their UV emissions. I'm curious if a 50W, 7500K conventional LED lamp emits any UV light. I found that a 200W tungsten lamp can emit up to 1.5 mW/cm² at 350 nm....
31 July 2024 3,843 7 View
Dear Researchers, Is it feasible to distinguish between alpha and alpha prime martensite in the Ti6Al4V alloy under rapid solidification in the as-cast state using XRD, in addition to...
30 July 2024 3,849 0 View
Please note it
29 July 2024 4,920 3 View
https://www.cleanteqwater.com/resources/case-studies/gold-mine-australia/
29 July 2024 5,161 1 View
What is a diamond open access journal and difference between green and gold access?
12 July 2024 9,717 3 View
could Nd (Neodimyum) doping into TiO2 because Nd's dense diameters are bigger than in TiO2
11 July 2024 2,350 2 View
I am trying to measure the plasmon resonance angle of gold film and pure water using the Kretschmann configuration and a 633nm laser. Without flowing water over the gold, I can detect a clear...
10 July 2024 4,719 3 View
Dear all, l need to help me to determine pore diameter. I got from BJH data the rp(peak area), Desorption Isotherm was 1.6 nm, but from Isotherm l got type lV with hysteresis H2 loop. Can l used...
10 July 2024 2,872 1 View