An open tank with 3 pipes work as feeders for a time dependent heating process of water through a circulation process with a heat pump. I would like to simulate this process by implementing a Comsol Multiphysics 4.3b version. I know in advance that the flow is in the Laminar region within the tank but it is in the Turbulent zone through pipes. I implemented the Nonisothermal flow module/Laminar interface. I had a problem with the outcome especially with the mass flow rate of water which I used at the inlet. I need to couple the model with Nonisothermal Flow/Turbulent interface for the feeders and a Laminar flow for the tank. How can I manage that?
Your reply is a well appreciated.
Ali