Does the pressure(-600 mmHg) affects pH?

When I conducted the degassing experiment using decompression under anaerobic condition(and I used ferrous based chelating agent), the oxidized ferric were observerd. So, could you tell me the...

03 March 2021 4,892 5 View

After a reference from Int J Body Compos Res, can any body help?

Hi, I am after the reference below, my library says it cannot obtain a copy either locally or internationally, any help appreciated! Chris Wang ZM, Heshka S, Wielopolski L, Pi-Sunyer FX, Pierson...

03 March 2021 6,193 1 View

Do anyone here can help us in the field of molecular docking?

We have synthesized various metal complexes with different environment around the metals. Now to see the application of synthesized complexes we need this study also. we are also interested in...

01 March 2021 1,899 2 View

Analysis of CRD two factor using R studio ?

Hello everyone. I have conducted the research on post harvest longevity of tomato crop using plastic packaging and different doses of chemicals as two different factors. The design of experiment I...

28 February 2021 8,189 3 View

What is the exact mechanism of the antimicrobial effect of local anesthetics?

The antimicrobial effect of local anesthetics has been known for more than 50 years, but it still seems to have an unclear mechanism of action. which bacteria? which concentration? etc etc. ....

27 February 2021 4,450 2 View

How can I selectively dry etch Ti on a polymer substrate?

24 February 2021 5,378 1 View

Resistivity of PVD TiNx thin films vs. N2 flow?

In the PVD of TiN thin films (~100A), I've found the resistivity of the TiN films dropped from ~100 to 60um*cm with N2 flow increasing up to the metallic mode ending point; then the resistivity...

21 February 2021 1,864 2 View

What are your alternative data collection methods during the pandemic? What are the pros and cons?

Dear colleagues We are exploring possible data collection methods for environment and behavior research in the context of architectural environments. Have you conducted any Post Occupancy...

16 February 2021 2,575 4 View

Can bio-decomposer be a successful alternative to reduce residue burning?

To maintain the proper crop plan most of the times there is not enough time to make the field ready for the next crop. In this particular context , can bio-decompser be a solution? What about...

16 February 2021 7,068 24 View

Is there any effective FEM solver to perform simulation of balloon inflation with large deformation (e.g. 300% strain)?

Hi! Thank you for your time, attention, and support. I am currently using FEM solver Abaqus to perform a set of balloon inflation simulations, trying to understand the deformation shape, stress,...

14 February 2021 2,524 4 View

How to use measure capacitance change in COMSOL time dependent study ?

I want to measure change of capacitance due to relative displacement between two parallel plates in COMSOL. Distance between two plates changes with time. So I'm using a time dependent study but...

26 February 2021 8,567 3 View

How the Ground Plane implantation is performed without damaging (and w/o varying the undoped nature) the top Si (8-10 nm) in FDSOI technology ?

It is a general practice to introduce Ground Plane in FDSOI devices under the BoX. The Ground Planes are introduced by Ion Implantation through Top Si layer and Buried Oxide. I wanted to know that...

24 February 2021 5,974 4 View

How to find the capacitive response frequency from the impedance plot?

I have done electrochemical impedance by using cyclic voltammetry for one organic material. from that, I plotted bode diagram. but actually, I am very confused about how to find the capacitive...

18 February 2021 3,023 3 View

How to get better phase shift in C-V curves for ferroelectric devices?

I tried to sweep my ferroelectric devices from -2V to 2V and then from 2V to -2V and The two hysteresis peaks are off by several microFarads. Should i increase bias voltage? I am doing these...

16 February 2021 8,514 2 View

High Power control for 48V battery pack - High current control?

Hi, I am working on 48V Lithium-Ion battery pack. I am wondering if there is fast MOSFET (or any other technology), to control the current of charging and discharging the battery with high...

20 January 2021 1,717 4 View

MOS Capacitor instance or a mosfet used as a cap (D-S-B connected to gnd)?

Hi, in Cadence Spectre simulations should I use a MOS cap instance or a mosfet (D-S-B connected to gnd) to simulate a real life MOS-cap? I tried both of them and they gave different results i.e....

26 December 2020 6,407 1 View

How can we maintain the two different DC high voltages of same polarity between parallel electrodes inside the vacuum separated by few millimeter?

I am trying to maintain two different high DC voltages of same polarity (either positive or negative) between two parallel electrodes separated by 500 um inside the vacuum. However, what I found...

21 December 2020 1,735 3 View

How to segregate electrode-dielectric and dielctric-dielctric interface polarization after Capacitance VS Freq. measurement using impedance analyzer?

After measuring the capacitance vs frequency for my MIM capacitor consisting of alternate layers of TiO2 &Al2O3 , there is a rise in capacitance value of ~ 20-160 nF at 100 hz, starting to...

17 December 2020 7,786 3 View

How to evaluate area under the discharge curve by using Origin software?

In case of Galvanostat charge-discharge, the discharging time used to evaluate the specific capacitance using following relation: C=I*t/m*dV. But when it comes to capacity, the area under the...

25 November 2020 1,856 1 View

How to structure a Knowledge Management model, to strengthen research and improve educational quality in higher education institutions?

22 November 2020 8,558 9 View