How to deal with the recudtion of amplification efficiency of indexed primers?

Hi all, I am now working with ITS2 sequencing library preparation. I had observed that after introducing adapters, linkers and barcodes to a primer, the indexed primers have a much lower...

27 January 2021 5,045 3 View

Asalam o alikum, Can anyone please help me in interpretation of XRD data?

Actually, I want to present the in table form (dcal , dexp, 2 thita, hkl) but don't know how to find these values from data.

28 December 2020 6,769 4 View

Is it need to test Cronbach's Alpha for extracted features from data?

As Cronbach's Alpha is usually used for test the reliability of measurements given by questionnaires, however, I wonder that whether I use this test for features extracted from behavioral data. I...

26 December 2020 9,602 2 View

Are there any DNA intercalators that do not have fluorescence?

I understand several normal DNA intercalators, such as ethidium bromide, acridine, SYBR et al. would emit fluorescence. Is there any kind of DNA intercalator that do not have fluorescence?

25 December 2020 688 3 View

How much the nanoparticles reach the inflammatory tissue?

Dear colleagues, I want to know the average analysis data of EPR effect on inflammatory tissue (acute lung inflammation/injury, ischemia/reperfusion, rheumatoid arthritis, and sepsis..) In...

22 December 2020 3,147 2 View

Doping of r-GO?

if the percentage of doping Au into rGO is too small 1~10%, is it not enough to prevent restacking of r-GO in xrd results, rGO peak appeared at 22.2 and also the peaks of gold nanoparticles so...

21 December 2020 6,091 3 View

XRD peaks for gold nanoparticles ?

is the concentration of gold salt that were added will affect on the peaks appeared. i added a very little amount of gold salt to dope graphene oxide and not all the peaks that proved the...

17 December 2020 9,275 3 View

If someone has the pdf file of below mentioned reseach paper?

14 December 2020 5,935 3 View

I saw sparkles in my samples?

i am trying to dope boron in graphene oxide , and after i take out my samples from the oven i put them in the microwave for 40 sec , and i saw sparkles . and fume also i couldn't understand why

16 November 2020 6,852 5 View

QUERY REGARDING acdS gene (ACC deaminase encoding gene) Amplification?

08 November 2020 3,249 2 View

What is the most Operating System (OS) which can be INSTALL on Tiny hard devices like Raspberry Pi (RPi) hardware ?

I'm targeting to deploy a mesh network and manually configure MANET routing protocols. I'm preparing scenarios, architectures, and hard devices needed to do that. Are there some step-by-step...

03 March 2021 1,931 5 View

How to normalise data on OPM package from R Studio ?

Good afternoon, I recently used OmniLog from BIOLOG for my experimentations : I tested the metabolism of different strains on 2 types of plates. I have 16 strains of 3 different groups...

02 March 2021 3,584 1 View

What is the density for pva electrospining?

I'm Juan Carlos, a high school student who is working with electropinning, I made an electropinning machine with a 21g needle and a 30kv high voltage source and the distance between my needle is...

28 February 2021 298 3 View

High aspect ratio hexahedral mesh optimization solver?

I am interested in evaluating mesh optimization solvers that converge to high aspect ratio unstructured hexahedral grids. In other words, I am interested in a solver that optimizes warpage,...

26 February 2021 7,279 2 View

How to plot the probability paper of Gumbel distribution using R programing?

In R-studio, there are many commands of Gumbel package. Arguments are also different. I`m asking about the alpha parameter of the Copula which must be greater than 1. If this is the one used to...

25 February 2021 5,229 3 View

Has anyone had luck using cell lines other than HEK 293 (such as COS1) to package lentivirus?

I am looking to package lentivirus in endothelial cells but I am opposed to using 293 cells due to personal ethics regarding the source. I have done some reading and saw that COS1, COS7, & CHO...

25 February 2021 3,030 1 View

Has anyone used the Illumina ITS1 primer sets?

Hi everyone, Illumina provides a list of primers to amplify with high taxonomic coverage the ITS1 region for further fungal sequencing, but I cannot find the exact amount necessary of each...

25 February 2021 6,969 3 View

No title

25 February 2021 5,713 1 View

How do you mesh a thin solid in Fluent?

Hello, I have used the shell function on SpaceClaim to create thin solids for the model I am studying. These are contained within an enclosure for my study. I chose this approach as it avoids the...

24 February 2021 8,856 3 View

Implementation of chance-constrained optimization problem via scenario approach?

23 February 2021 7,826 2 View