ADMV1013 is an upconverter.
I have two files. the first name '' ADMV1013-EVALZ_Board_Trace_DEEMBED_Files '' and the second name '' ADMV1013_S-parameter_s1p ''. I have asked some explications about thess files on analog device site and this is the answers of ingeniers : '' The S Parameters for the relevant pin of the IC represents the return loss of that pin. (1 port s parameter, 2 port also available for some differential pins).
The S Parameters of the trace deembed files represents the S Parameters of that RF trace on the evaluation board (usually 2 port, 4 port also available for some differential traces ''
My objective is the conception of this upconverter on ADS.
Is it possible to design this upconverter with these two files ?
If yes, how do I proceed?
If no, how do I do to design this upconverter model in ads ?
The ADMV1013 is a wideband microwave upconverter that accepts an input IF frequency of 0.8 to 6 GHz and upconverts it to an RF frequency from 24 to 44 GHz.
Please find the attached pdf.
Hi Ahmed Jamal.
I would like to design this component in ADS. But, ADS don't contain equivalent model. So I downloaded two folder in their site such as '' ADMV1013-EVALZ_Board_Trace_DEEMBED_Files ''. this folder contains S parameters of trace of deembed. Also, another foll=der that I downloaded is '' ADMV1013_S-parameter_s1p''. This folder contains S parameters of pin.
So I want to it is possible to design ADMV1013 with the contents of two folder on ADS ?
- Badges
- Science topic
- Similar topics
- Filing