Can any one kindly help me to get Master fellowship leading to PhD?

Warm greetings, I am master degree graduate from Tribhuvan University Nepal. My major subject in master is Zoology (Parasitology). I have done research works on Plant nematodes and i am searching...

25 July 2020 397 3 View

How to optimize cohesive zone failure parameters in peel test in Abaqus?

I am doing cohesive zone modeling in abaqus. I am trying to find out vales of 'E/Enn', 'nominal stress normal only mode', and 'normal mode fracture energy' by peel test.

13 January 2020 7,315 1 View

Which gel will be appropriate to use detect 3.5 kDa protein by western blotting?

I want to detect a 3.5 kDa protein by western blotting and was wondering about the appropriate materials and conditions to follow. Please share your practical experiences. Thanks!

06 August 2019 5,657 3 View

How can "nano particle docking" studies be carried out with protein?

Can anyone tell me how to model a nano particle using computational softwares (or servres)? I am interested to carry out molecular docking using nanoparticle and protein and for that I need to...

09 April 2018 6,867 5 View

How can I create SMEs (superconducting magnetic energy storage) coil block in MATLAB simulation?

How can I create SMEs (superconducting magnetic energy storage) coil block in MATLAB simulation?

27 December 2017 5,373 4 View

Have anyone worked with Adhaeribacter aerophilus ?

27 March 2017 3,374 6 View

Is Direct displacement based design (DDBD) method applicable to design a 90 story (320 meter) building ?

Is Direct displacement based design (DDBD) method applicable to design a 90 story (320 meter) building ? If not then which design philosophy is required ? give some related papers.

21 March 2017 6,248 1 View

How can I confirm the presence of Si3N4 amorphous in a thin film?

I am trying to deposit Si3N4 amorphous thin film by reactive radio frequency magnetron sputtering.

04 January 2016 549 10 View

Any suggestions as my plant isolate does not dissolve in anything?

Hi, I have a plant extract fraction that I want to dissolve in a solvent. Tried all solvents possible from Hexane, benzene to DMSO and water. Did not dissolve in anything. Any suggestions?

04 March 2015 6,578 10 View

How can I resolve my two carbon peaks which are inside DMSO in carbon NMR?

I have two carbon peaks of my sample that are superimposed with DMSO peak in carbon NMR. I got to know of this from HSQC and HMBC. Is there any way that I can bring them out ie change their shift...

14 February 2015 6,883 8 View

What's the best way to measure growth rates in House sparrow chicks from day 2 to day 10?

What's the best way to measure growth rates in House sparrow chicks from day 2 to day 10? Since, the growth curve from day 2 to 10 won't be like the "Logistic curve" it might not follow logistic...

03 March 2021 1,401 3 View

After a reference from Int J Body Compos Res, can any body help?

Hi, I am after the reference below, my library says it cannot obtain a copy either locally or internationally, any help appreciated! Chris Wang ZM, Heshka S, Wielopolski L, Pi-Sunyer FX, Pierson...

03 March 2021 6,193 1 View

Irradiation data for JAPAN?

Hi, Could you help me to get the latest (2019, 2020) solar resource data for a particular site in JAPAN? PV GIS and NSRDB data are not in reach to JAPAN, I'm looking for some other database for...

03 March 2021 961 3 View

What techniques can I use to determine the miscibility of polymer blends?

The term miscibility refers to the single-phase state in thermodynamics. I do not mean the compatibility of different components. To determine the miscibility I know several techniques such as...

03 March 2021 4,107 4 View

How to repeat an operation on an atom selection for multiple times in PyMol?

Hi, I am trying to construct a multi-layer fibril structure from a single layer in PyMol by translating the layer along the fibril axis. For now, I am able to use the Translate command in PyMol...

02 March 2021 4,569 4 View

Shall I skip the measurement model in SmartPLS?

Hello everyone, I had run a mediation model in SmartPLS using questionnaires that were already validated among my statistical population. A professor who edited my paper -though she is not...

01 March 2021 3,052 3 View

What is involved in morphological changes of SEM images of a substance?

In the sem analysis of CaCO3 nanaoparticles, the morphology images showed spherical shaped particles but the proposed morphology for these type of nanoparticles is trigonal. I prepared the...

01 March 2021 1,960 4 View

Joint behaviour in Abaqus is not captured well?

I am working on roof joint and trying to simulate the behaviour in Abaqus. I am successful in running the model but the final graph does not follow the experimental curve in the negative direction...

01 March 2021 6,661 3 View

How to define tie constraint between rigid body and another part in dynamic explicit model of Abaqus?

Hi dear researchers I connected a rigid body into the part of my structure by tie constraint and then I added displacement to rigid body, in static general step every thing is fine and these two...

28 February 2021 3,442 2 View

Does the circuit modeling for planar monopole antennas using Foster canonical forms give good approximation?

Hi researchers, I am searching for some accurate way to do the circuit modeling of planar CPW-fed monopole antennas. I have gone through the literature where mostly circuit modeling is done using...

28 February 2021 7,016 1 View