Dear researchers
I would like to calculate the thickness of a thin film deposited on a glass substrate from the transmittance given by the Uv-vis measurement.
Best regards.
You can fit thickness using software from Article Analysis, Optimization, and Characterization of Magnetic Pho...
Thickness also can be possible to calculate by using the maxima, and minima of the transmission spectrum by using Swanepoel method. See an example in this useful link: https://www.mdpi.com/2079-4991/8/5/355
I have a response variable called skin yellowness, which I will measure via a scored color chart, whereby 1 is pale yellow and 15 is orange. I'm not sure if this counts as an ordinal variable,...
11 August 2024 4,793 1 View
Approximate concentrations are require in compared with the WHO permissible limts
11 August 2024 2,723 1 View
how can I read Waters, R. S. 1958. Morphological mapping. Geography 43 :10-17 from internet? note: not in google or resaearch gate
26 July 2024 7,813 3 View
How can the rubber fibres produced by the electrospinning device be removed from the fibre collector (aluminium foil) without affecting the orientation of the rubber fibres for use in reinforcing...
26 July 2024 8,281 0 View
Despite not having cells in the media, I am getting purple color. I have tried many troubleshooting methods, varying media types, and even different MTTs from different companies to figure out the...
21 July 2024 9,914 1 View
As PhD student specialized as food and industrial microbiology need to further research on bacteriocin and fermented food.
16 July 2024 7,394 1 View
What are some of the areas to consider in undertaken research in educational administration in MPhil.
14 July 2024 8,394 2 View
XRD analysis
08 July 2024 977 4 View
how i can calculate mathematically COD concentration if i add 1gr from glucose to 1 L distilled water
08 July 2024 9,104 2 View
Previously, I successfully modelled the transmission and reflection of electromagnetic waves incident on non-magnetic materials. Please refer to my publications for details: 1- A polynomial model...
05 July 2024 1,396 2 View
A crude extract of fungal culture using EtOH was subjected to column and TLC and partially purified compound was obtained. UV vis spectrum of the compound/s has max absorbance at 218nm. The...
11 August 2024 9,801 2 View
Hello, Why do i see this baseline drift when i compare my blank (black) to the sample (blue)? Any suggestions as to why this happened? Thank you!
11 August 2024 3,770 4 View
I need a very narrow glass capillary for my research. How can I make a glass capillary with an inner diameter of around 200 to 500 nanometers?
08 August 2024 8,915 0 View
For example, I perform passivation process before electropolymerization of Py for adhesion to titanium surface. Is a similar or different procedure required for ITO? If necessary, I would be glad...
06 August 2024 3,176 0 View
How can I measure the thickness of thin film by Uv-Vis?
06 August 2024 7,810 3 View
Hello everyone, I'm encountering an issue with my electrochemical impedance spectroscopy (EIS) measurements and would appreciate some insights. Experimental Setup: Electrodes: Gold interdigitated...
05 August 2024 3,783 2 View
Why is TLC not a form of partition chromatography and paper chromatography not a form of absorption chromatography?
03 August 2024 7,035 3 View
What types of mask designs for metal deposition, to be used in a PVD system, are best suited for perovskite-based solar cells?
31 July 2024 4,835 3 View
I'm researching light sources and their UV emissions. I'm curious if a 50W, 7500K conventional LED lamp emits any UV light. I found that a 200W tungsten lamp can emit up to 1.5 mW/cm² at 350 nm....
31 July 2024 3,843 7 View
I need something like Camag's VisionCat software for photodocumentation of TLCs. Could you recommend something?
31 July 2024 8,415 1 View